KV32TS46 Repair Tips
Search: KV32TS46
Results 21
Results 21
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Sony | KV32TS46 | NO PICTURE, REPLACED HOR. DRIVE TRANSFORMER | No high voltage | ||
Sony | KV32TS46 | NEW CRT, "C" BOARD AND YOKE, SEE SB 201 & SUPPLEMENT -1 | New type of CRT being used. It no longer requires the Hor.Stat control, also circuit change made to Heater circuit. Yoke P/N hasalso been changed. HQ COMMENTS: Please refer to Service Bulletin number 201 andService Manual Supplement-1. | ||
Sony | KV32TS46 | "D" BOARD P/N IS REVERSED, SEE SB 219 | The part number for the D Board used in the 27 and 32 inchsets are reversed. | ||
Sony | KV32TS46 | IC610 P/N INCORRECT, 8-759-708-05 | Part number in S/M for IC610 is incorrect. Please help -HQ COMMENTS: The correct part number is 8-759-708-05 NJM78L05A | ||
Sony | KV32TS46 | UNABLE TO CHANGE CHANNELS IN PIP, RESET ID CODE 52/53 | Using remote control and pressing P-P for display, unit ok.Tried changing channels and could not change channels. | ||
Sony | KV32TS46 | DEAD, NO STANDBY 5V, REPLACE IC602 RESET IC | Unit won't turn on, no standby 5v to IC101. Unsoldering thereset line, pin 4 of IC602, the unit powers up. | ||
Sony | KV32TS46 | INTERMITTENT WHINING IN THE SOUND, REPLACED TUNER 859803901 | Intermittent whining noise in the sound. Sub in an IF signal with audio and unit is ok. | ||
Sony | KV32TS46 | RED AND GREEN COLOR DISTORTION, REPLACED THE "P" BOARD. | Red and green colors distorted, blue OK. The chroma signalbecame distorted in passing through the P board. Replacement of thatboard corrected the problem. -HQ COMMENTS: The P Board is the PIP circuit board. Chroma issupplied to IC3204/pin 39 and exits | ||
Sony | KV32TS46 | DASHED LINES IN CHILD PICTURE, RESOLDERED D3202 | Unit had problem in child picture only. Picture had dashedlines in center portion of child picture. | ||
Sony | KV32TS46 | TV CABINET BUZZES WITH AUDIO, APPLY RTV BETWEEN CRT & BEZEL | This is the second unit at the same shop with this problem.At approximately 30% volume the cabinet buzzes and rattles. Mostprevalent at 187HZ audio input. | ||
Sony | KV32TS46 | JVC AND HITACHI VCR CODES MISSING FROM O/M, ADD CODE 35, 36 | Customer could not get their JVC VHS deck to operate usingthe code 16 as stated in the manual. Noticed their RMY-113 remotestated to use either 16 or 35. When they tried code 35 it worked. | ||
Sony | KV32TS46 | SQUEAL, SEE BELOW ALSO TVP SB #184 | Squeal coming from set. -HQ COMMENTS: Refer to TVP SB number 184 for additional information. C-503 Replace C-519 Move cap away from touching shield. C-548 Move cap away from touching shield. L-509 Apply Silicon in vicinity of L-509 | ||
Sony | KV32TS46 | D612 P/N AND DESCRIPTION CORRECTION | D-612 on page 112 is listed as D5SC4MR P/N 8-719-031-80 this is incorrect. -HQ COMMENTS: The correct description and part number is listed below: D612 D5SC4M 8-719-031-79 | ||
Sony | KV32TS46 | PICTURE FLICKER, (VERT JITTER) YOKE WIRE TOUCHING MAGNETS | When the set is cold the picture flickers for several seconds.After warm up it stops and may flicker again after 20 minutes. Theproblem is caused by interference getting into the cable harness from theyoke magnets to the board. -HQ COMMENTS: The prob | ||
Sony | KV32TS46 | VERTICAL JITTER AT TURN ON, REPLACED C334 ("M" BOARD) | Set had severe vertical jitter at turn on, but wouldoperate normaly after a few minutes. ASC located a bad capacitor C334off IC301/pin 32 on the M Board. Capacitor checked good, out ofcircuit, but was heat senitive in circuit. Replaced with exact replac | ||
Sony | KV32TS46 | REMOTE OPERATION ONLY FROM SHORT DISTANCE, IC1001 | Remote only works at close range, and is affected bylight. It normaly should work up to at least 7M (21 feet). -SOLUION: Replaced IC1001 on the H Board. -HQ COMMENTS: Make sure the Suffix on the chip IC-1001 ends in 51.Chips ending with H9 have been f | ||
Sony | KV32TS46 | SUPER WOOFER BOARD P/N IS INCORRECT, CORRECT # 9-904-754-01 | The part number A-1331-264-A, for the Super Woofer completeboard, on page 118 of the Service Manual, is incorrect. HQ COMMENTS: Please use the Service Manual SA-W200, for the Super Wooferfor the correct part numbers. The correct part number for the | ||
Sony | KV32TS46 | NO BEEP SOUND WHEN USING CODE SET FUNCTION, NORMAL | Owners manual states A long beep sounds, indicating that thecode has been set. Customers remote (RM-Y118) does not beep. Is theOwners Manual correct or not? HQ COMMENTS: The Owners Manual is incorrect. No beep sound will be heardwhen the code set is co | ||
Sony | KV32TS46 | HIGH PITCH SOUND FROM SET, C-519 TOUCHING SHIELD | High pitched noise comes out from back of TV. | ||
Sony | KV32TS46 | ANT/AUX SWITCHING NOT MENTIONED IN O/M | This model has AUX antenna input for use with scrambled cablesystems. To access this input you have to press the TV key (middlesecond row of buttons) on remote RMY-118. There is no mention of this inthe owners or service manual, in fact diagrams do no |