Cce LT32G TV Repair: Common Faults and Solutions.
Search: Cce LT32G
Results: 10
Results: 10
Cce LT32G Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| CCE | LT32G | When turning on the power, fast red blinks and then flashing blue and it takes well until standby, after tightening Power it is flashing blue again takes well and does not light the backlight, illuminate with a flashlight is written CCE and is indefinitely, ie, processing stick, memories. sound uses memory 25L1606e. | I wrote to warn friends that this is not the memory U103, memory 25L1606e, because I physically rewrite the memory, I updated via pen drive and nothing. I removed the memory I recorded and put it on another sign that worked perfectly. | So I concluded that the defect is not a memory U103, unfortunately I could not solve, it must be the Flash Nand memory, this I did not replace, disappoint friends but will not time Iguel I lost thinking that the memory U103. | MIGUELTV |
| CCE | LT32G Gt1326ex d292 | LED is flashing blue and red | Don't turn on | ANAILTON | |
| CCE | LT32G LT32G | Do not light the LEDs | Diode with altered internal capacity (it seems like joke) measuring this good, but in the equipment of the low capacitance. | Diodo D3 (SB5150) | Johnatan |
| CCE | LT32G GT-1326EX--D292 | LED current reduction | Change r65 from 1k2 to 6k8 | Ederlin | |
| CCE | LT32G GT-1326EX-D292 | High voltage on the LED causing it to burn | Replace r9 with a higher value, in my case I put 2 15k res in parallel the voltage dropped from 6.2 to 5.9 | eletronica tensao | |
| CCE | LT32G | Don't tune in | Change varicap from another cce board that is a similar model ln32g, etc. | reginaldo moronte,eletronica junior caldas novas | |
| CCE | LT32G | Bus lighting very weak, switch ci voltages normal | Replace q4, with a small leak, heating beyond normal | José Moura | |
| CCE | LT32G | Does not turn on backlight | Altered or open resistor r130 that powers the driver IC | Eletrônica Pauly | |
| CCE | LT32G | If, when you replace the card for another, the image turns upside down | Just replace the flash memory u103 | Reinaldo | |
| CCE | LT32G | Tsound is sound, no image, when turned on the LEDs blink | The voltage of the LEDs is below 54 volts | Test the LED power supply, if it is below 54 volts, replace the EC2 100x160v electrolytic for a new one and just be happy | Paulo Sertel-Itararé SP |