Jvc TV Repair: Common Faults and Solutions.


AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HISENSE
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: Jvc
Results: 434

Jvc Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
JVCC14ET1EK -ONWA
DeadC909 47µ had exploded & perlace c911 47µ 50v. no ht when replaced - r404 1r0 safety res o/c in 16v supply
JVCC14ET1EK ONWA
Wriggling line at bottom of pic (after repairing blow up)12v line low at 11v - fusble res r434 0r68 had risen in value
JVCC14ET1EK ONWA
Sync crushing with soot and whitewash picC113
JVCC14ET1EK ONWA
Poor field syncC308
JVCC14ET1EK ONWA
Patterning & no colourCf101 in if o/c
JVCC14ET1EK ONWA
No txtC020 3µ3 50v o/c
JVCC14ET1EK ONWA
No sound with slight whistleC106
JVCC14ET1EK ONWA
No soundC110
JVCC14ET1EK ONWA
Int reverts to st/byLeaky tactile switches
JVCC14ET1EK ONWA
Failure to stop on search tuneCheck ident cct - q614/615, caps, 1n4148 diodes d609/610
JVCC14ET1EK
Tunes ok but goes off tune when "memory" pressedT106 afc coil o/c in if can
JVCC14ET1EK
Surge lim res o/cCheck c904-7 4n7 disc caps across mains rects
JVCC14ET1EK
Standby onlyR403 0r68 1w o/c (ht feed)
JVCC14ET1EK
St/by onlyR323 6k8 5w feed to an5601k ic301 o/c
JVCC14ET1EK
Sound muted/erratic non-lin field at bottom - check if auto tune stops at a chan - if not change:-Q605, q618, q619, q620, q621, 2sc1815-y. d607 & 8 1n4148, r403, 404, 433, 434, 435, 0r68 1/2w safety res, q402 2sd400f, c406 220µ 25v, c433 220µ 35v. in this case just c433 was faulty
JVCC14ET1EK
Set switching to standby.R323 6k8 , 5watt fusible resistor o/c.
JVCC14ET1EK
Relay chatters at sw on then shuts downC402 4n7 in ht snubber leaky
JVCC14ET1EK
Red excessiveQ502 s/c on crt base
JVCC14ET1EK
Over bright pic with smearingHt to rgb o/p low (180v) r435 0r68 fusible o/c
JVCC14ET1EK
No vol/brightness osdWhen vr601 adj, bars appear but compressed - ic602 tms73c47