Search: Mitsubishi TC 2098
Results: 24

Mitsubishi TC 2098 Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
MITSUBISHITC 2098
TV turns on normally and turns off in a few minutes and doesn't turn on againR563 in the open acl line change the sameFrancesco eletrônica Gine
MITSUBISHITC 2098
Power supply grilling-noise near the trafficCond. c907 22x100 replace without testingkin
MITSUBISHITC 2098
When turned on, it lights up stand by and tries to oscillate once, then press power and it doesn't work.You can see that when the LED is plugged into the socket, it lights up weakly and then brightly but nothing.Disconnect the kinescope pacifier if the tv works replace the trc.Dé Andrade
MITSUBISHITC 2098
Reduced picture, looking like a bad power supply capacitor.Normal power supply.Replace horizontal width capacitors, 4.7 and 5.6x1600volts.Dé Andrade
MITSUBISHITC 2098
Standby LED flashes and does not turn onPower supply capacitor c 907 change attention note...do not test on the capacitor as it will give the right capacitance but does not work on the circuitjoão dantas
MITSUBISHITC 2098
No image with horizontal sync listsCapacitor 208 de 1x50 v.Alvanyr This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHITC 2098
Turns on, after turning off, it doesn't turn on againCheck ci 901 feedback componentsIn my case, the cap. 905 of 220 by 16v was exhaustedJUNIOR SYSTEM ELETRONICA
MITSUBISHITC 2098
Poor widthCapacitors 555 and 556 of 5n6 and 4n7Replace - check the power supplyMoré
MITSUBISHITC 2098
Power supply grilling-noise near the trafficCond. c907 22x100 exchange without testingkin
MITSUBISHITC 2098
When turned on, it lights up stand by and tries to oscillate once, then press power and it doesn't work.You can see that when the LED is plugged into the socket, it lights up weakly and then brightly but nothing.Disconnect the kinescope pacifier if the tv works replace the trc.Dé Andrade
MITSUBISHITC 2098
Reduced picture, looking like a bad power supply capacitor.Normal power supply.Replace horizontal width capacitors, 4.7 and 5.6x1600volts.Dé Andrade
MITSUBISHITC 2098
Standby LED flashes and does not turn onPower supply capacitor c 907 change attention note...do not test on the capacitor as it will give the right capacitance but does not work on the circuitjoão dantas
MITSUBISHITC 2098
No image with horizontal sync listsCapacitor 208 de 1x50 v.Alvanyr This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHITC 2098
Turns on, after turning off, it doesn't turn on againCheck ci 901 feedback componentsIn my case, the cap. 905 of 220 by 16v was exhaustedJUNIOR SYSTEM ELETRONICA
MITSUBISHITC 2098
Poor widthCapacitors 555 and 556 of 5n6 and 4n7Replace - check the power supplyMoré
MITSUBISHITC 2098
High-frequency noiseCapacitor c 596 (10 uf x 160v) with loss of capacitance or high esr
MITSUBISHITC 2098
Power supply transistor c 3852 overheatingCapacitor c 906 (47 u f x 50v) with loss of capacitance or high esr
MITSUBISHITC 2098
No plot, no matSolda fria no pino 1 do fly - back
MITSUBISHITC 2098
Frame closed on all four sides, normal image and audioCapacitors c 555 and/or 556 (4 n 7 x 1.6 kv) open or with cold solders
MITSUBISHITC 2098
Does not work, panel LED is onTransistor 2sd1877) in collector - emitter short due to loss of capacitance (4n7 x 1600 v)