PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14173
Results: 14173
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | FWM589 | Doesn't start | Exchange c2909 | C2909 470n replace | domigos sp |
PHILIPS | 14PT3131 | Turns on the image appears and then turns off | Defect was found in the rgb pci of the tube | In my case it was the transistor 7318(bf423) short and the resistor 3318(220r) open tip check them all. | eletronica fernandes |
PHILIPS | 29SX8879 | Doesn't turn on, no +b | R 3138 33k aberto | Master Eletronica | |
PHILIPS | PT3336 | I'm here | E-pron | juvenal-picos-pi | |
PHILIPS | DVP3142KM/78 DVD | He left | Change resistor r76 dvd returned normal | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILIPS | 21PT6437 | Fully closed vertical | Ra 445 | Replace r3445 of 1r 1/2w tv came back normal | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 20PT228A | TV without video and sound | D 6405 | Replace diode d6405 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILIPS | 20PT326A/78 | Turns on, standsby but there is no image, when changing channels the LED flashes but there is no brightness on the screen. | Adjust the flyback screen, if it is off the screen does not light up | Eronaldo | |
PHILIPS | 20GL1346 GR1-VA | When turning on no image, no sound. with filament. when increasing the screen it only gave a return trace | C2410 100/25v with low capacitance close to the vertical ci | After replacing it, the TV was ok | Jose Gusmão |
PHILIPS | 20PT3331 | When turning on, 3 lines appear at the top with the image closed a little and then it turns off | Capacitor poliester c2460 de 68k/250v | José Gusmão | |
PHILIPS | 20PT3336 | It would turn on, after a few seconds it would turn off, the channel number would be streaked | I changed the photo coupler, it was ok. | wilhelm | |
PHILIPS | VR 788 | When inserting the VHS tape, it pulls and turns off. | The head cylinder does not rotate. | Oxidation on the board, measure and make a jumper. | azaujotec |
PHILIPS | 29PT4631/78R | When turning on the TV, the image appears with aliasing and a slightly reduced horizontal, then it turns off and when turned on again, the TV works normally. | Capacitor c2455 47mf25v with low capacitance. | Replace for another one, but you can put a 47mf 50v one | ROBERTO |
PHILIPS | TP4635 | Turns on, turns off and on the screen it appears when the horizontal trident is broken but it doesn't have it | I just had to change the electrolytic capacitor 2455 47x50 eos transistor 7461bc337 and 7463bc227 and run to hell | atonio | |
PHILIPS | 21PT534 | When turning on the LED flashes once and returns to standby | 3470 open resistor | eletronet | |
PHILIPS | 29PT4641 | Turning off when changing channels | As incredible as it may seem, it's a cold solder on the secondary ground "pin 12 of the flyback" | novaeletronicauberlandia | |
PHILIPS | 20PT3331 L03.1L AA | Changing audio amplifier | The power supply works and the voltage drops and the TV doesn't turn on. | Changing audio amplifier | johnny busnadiego |
PHILIPS | 29PT9467 | Buzzing in sound | As a testimonial | C879 replacement | DIGITAL TEC |
PHILIPS | 20PT122A/78R | Black band on the left side of the screen about 5cm wide pushing the image horizontally | D6464 - diode in4148 shorted. | The same was replaced | Hunter_40 |
PHILIPS | 42PFL5332/78 | Dark image in the center of the screen and noise in the inverters | U202 photo aclopador na pci power supply | Replacement | paulo maceio/al |