PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14173
Results: 14173
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29GX1895 ANUBIS S | Does not exit demo mode | Ground pin 20 of the micro | With the TV turned off, ground pin 20 of the computer and turn on the TV, an image with drizzle will appear, then turn off the TV, remove the ground and that's it. | johnny busnadiego |
| PHILIPS | -TFT 170S A3KM118 | Monitor does not start. | Replacement of 25v/470u capacitors 2117, 2118 and 25v/220u capacitor 2122 | Look for the schematic in the monitors section. | batraquio |
| PHILIPS | 14GL1013 | Without tuning, vhf channels blocked all on vhf prim.emiss.de and uhf on uhf prim.emiss. | Check power line. which goes from pin 1 of the computer to the selector. | Open 10k 3962 resistor. | ELETRÔNICA ESTUDIER- CANOAS-RS |
| PHILIPS | GL1316 | High power supply | C2347 e c2346 valor 47*160 | dede som | |
| PHILIPS | 21PT232 L7 PLUS | Does not turn on, normal power supply, standby LED blinking | Eeprom with corrupted data | Rewrite the eeprom | alexsts |
| PHILIPS | CDC 265 | Display or viewfinder off | Burned out lamp | edinho | |
| PHILIPS | AZ1134 | Cd doesn't work | Smd capacitor on 8v supply with leakage | Rubens | |
| PHILIPS | 20PT3331 | It doesn't turn on the power supply ok, it doesn't oxilate s.h. | C2429 = 220n with leakage connected to the t7423 emitter | Bruske | |
| PHILIPS | 20PT524A | Does not activate | Fly back/trans.sh collector pin with 34v when you open this pin or pin 1 and 2 of the fly back the voltage goes to 98v. | lpinheiro | |
| PHILIPS | 29PT552 | Burning the vertical outlet | Place a wire from the deflector clamp to the ground of the tube | Replace the capacitor c2404 of 100p, 22k put the diode cathode on pin 5 replace r3488 from 4.7 to 5.6 and great | miltom |
| PHILIPS | 20GL1045 | Just the sound (increasing the screen the image is flat) | C 2140 100ufx25volts capacitor no apagamento vertical | HP ELETRONICA | |
| PHILIPS | 20PT3336 L03.6L | Power supply overheated, colors fluctuated and turned off | Capacitor 2503 | Reginaldo | |
| PHILIPS | 20PT3331 | No sound | Test 1: if the sound reaches the sound output, disconnect pin 9 from the output, if the sound is loud, replace the smd 6908 zener diode... test 2: if the sound does not reach the sound output, just reconnect one tweezers, with the TV on high volume, shorting out the caps. smd 2201 and 2202 are close to pin 31 of the processor, which outputs sound you change. good luck | In my case, I did test 2, and it was the smd 2202 cap. | SYSTEM ELETRONICA JUNIOR |
| PHILIPS | 29PT5642/78R | Vertical, with three colored lines at the bottom of the screen | Diodo smd 6457, l0mfxl00v e 100mfx50 | eduardo | |
| PHILIPS | PIPO 14GL1319 | Has sound and no image | Open resistor r3020 16k | Replace it and it's ok. good luck | eletroclaudiope |
| PHILIPS | 29PT4635/78 LO1 | This TV arrived at the workshop with the vertical closed. the resistor in position 3479 of 2k7 open, was the cause of the problem. I replaced this resistor, and the device started to work normally for a few hours, until I noticed that the screen darkened and brightened slightly and then, it darkened once and for all, leaving the sound and normal OSD. After researching a little more, I found the smd transistor in position 7204 shorted. Once this resistor was replaced, the device started working normally again. | The 2k7 smd resistor in position 3479 open, was the cause of the closed vertical. the smd transistor in position 7204 bc857b, responsible for dimming the screen. | jfr | |
| PHILIPS | 14PT110A | It doesn't turn on, if you enlarge the screen, retrace lines appear | Replace saida vertical tda3653b | MB ELETRONICA | |
| PHILIPS | 20PT428A | The device is switched on, after a few seconds dark ripples appear horizontally, and the device switches off. | Electrolytic capacitors: 2561 and 2409, both 47uf x 160 v. located at the power supply, replace them, it will be ok. | Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, JATAÍ-GO, This email address is being protected from spambots. You need JavaScript enabled to view it.. | |
| PHILIPS | 29 PT 4635/78 | Horizontal line to your right only with weak signal, with barabolic signal and av all normal | In my case I changed the transistors: q7461 and q7463 | Replace q 7461 and q7463 bc 337 and bc 327. good luck! | ELETRÔNICA JUCÁ |
| PHILIPS | 21PT5433/78R | Dead | Transistor 7423 (bc807-25) | Replace of the same | Bomtempo Mecatrônic |