Search: PHILIPS
Results: 14173

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPSFL1.6
Fall off position 3204 on the large signal panelFall off position 3204 on the large signal panel ------------------------------------------------ when position 3204 (ntc/ptc; 4822 116 40215) on the lsp is defect it is recommended to replace it by a ptc/ptc (4822 116 40253). together with this change al
PHILIPSFL1.6
Disturbed sound on left channel.Check ic7009 (4822 209 83163; lm833) on lsp.
PHILIPSFL1.6
Digital noise in picture. most blue colour.Output of ic7206 (dram tms4c1050-3n in the lfr) pin 10/11/12 is 2.5v instead of 5v. replace ic7206 (4822 209 60525).
PHILIPSFL1.6
Dark foggy picture, even with max. contrast and brightness.Black level of y output on connector 1h21 of the lfr (proscan) box at 0,3v (instead of 0,1v). replace ic7209 (4822 209 31059; saa7158).
PHILIPSFL1.6
Correction to the electrical adjustment 7.2 of theCorrection to the electrical adjustment 7.2 of the service manual fl1.6 aa. ----------------------------------------------------------------- cut-off alignment switch the set into 4:3 mode. switch out the dnr via the remote control. select a black picture
PHILIPSFL1.6
Correction on service information.Correction on service information fl1.2 ab/bb 92.05 (4822 727 19773) fl1.6 aa 92.01 (4822 727 19778) --------------------------------------------------- at point 3/1 (new xicor) is mentioned: add position 6135 (4702). this should be: add on position 6
PHILIPSFL1.6
Correction of diagram m` of service manualCorrection of diagram m` of service manual ------------------------------------------ the diagram/partslist of the lfr (digital scan) box shows ic7244 typenumber n74f74d. however on this position an ic with typenumber n74f125d (5322 209 61857) is used.
PHILIPSFL1.6
Colour was shifted to the left and only red and blue.Black and white picture signal on ic7366 pin 11-12. replace ic7366 (4822 209 63108; tda4660) on ssp.
PHILIPSFL1.6
Colored picture or picture is green/red, fly-back linesCheck zenerdiode 6450 on pin 19-ic7430 on the lsp. new diode must be philips (telefunken does not work), 4822 130 81512
PHILIPSFL1.6
Child lock was activated (tv only working in service default mode).Replace eprom ic7137. add protection ic mc3364p (4822 209 31294) as described in service information fl1 93.02 (4822 727 19885).
PHILIPSFL1.6
Change of ic7201 and ic7215 to saa9042p/a/mobChange of ic7201 and ic7215 to saa9042p/a/mob -------------------------------------------- ic7201 in the high end box and ic7215 in the lfr (digital scan) box have been changed from saa9042p/a/moa to saa9042p/a/mob (4822 209 31851). remarks : t
PHILIPSFL1.6
Bux85f in mikrosops defectiveChange the value of c2260 to 4n7f, replace 7270 with transistor bd825 (4822 130 41746).
PHILIPSFL1.6
Bad focus or picture shuts off with flyback linesCreate an artificial flash-over in the crt, by short circuiting vg2 and focus and connect them for a short moment to the aquadag. remarks : in production modified tubes are introduced in week 9225
PHILIPSFL1.6
Bad focus or focus varies in a new set or after crt replacementPossible solution: short circuit the focus and the g2 pins of the picture tube with the aquadag coating. switch the set on for approximately 5 seconds. after this return the set to its original condition. check if the focus adjusted normally. if not repla
PHILIPSFL1.6
Audio signal from tuner audible during silent passages of vcrThis fault occurs when the volume-setting is higher than 50%. service solution: ----------------- add an extra circuitry which uses the cvbs-status via scart connector as a switch function. with this signal input from the vcr, the audio signal from tuner
PHILIPSFL1.6
Antenna input: no sound. external input: sound o.k.Check whether crystal 1602 (stereo decoder) 10mhz oscillates. if not replace x1602 (4822 242 80276).
PHILIPSFL1.6
Alternative for a66eak252x43Alternative for a66eak252x43 ---------------------------- the following blackline s tube will no longer be supplied: 28" a66eak252x43 4822 131 20502 this has been replaced by: 28" a66eak252x44 4822 131 20567 remarks : if an old picture tube
PHILIPSFL1.6
After one hour picture jumps verticallyBurst key 50 (bk50) on lfr (digital scan) box is 10vtt with 50hz frame sync. instead of 5vtt without frame sync. check d6001 (llz-c5v1 4822 130 80884) on lfr box.
PHILIPSFL1.6
After a while stripes in pictureIc7430 (tda4680) defective (4822 209 31592).
PHILIPSFL1.6
After 10 minutes picture becomes red from right sideC2395 on the lsp poorly soldered.