Search: PHILIPS
Results: 14173

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPSFL1.1
Txt does not work, linesDiode 6200 in high-end-box defective.
PHILIPSFL1.1
Txt does not work from time to timePin 8-ic7201 poorly soldered. ic7201 (saa9042) defective.
PHILIPSFL1.1
Tuning does not functionResistor r3240 on lsp in v-tuning wire broken.
PHILIPSFL1.1
Totally inoperative.Transistors 7250 (bux85f; 4822 130 62509) and 7251 (bc848; 4822 130 61207) in microsops defective. or d6251 (llz-c5v6; 4822 130 80954) and r1250 (=r3230; 1Ω; 4822 052 10108) defective. or t7270 (bd825; 4822 130 41746) or t7201 (bc857c; 5322 130 427
PHILIPSFL1.1
Total inoperative, leds blinking, error 99Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2,
PHILIPSFL1.1
Ticking noise and line in pictureTransistor 7381 (bc848c; 5322 130 42136) defective when hot.
PHILIPSFL1.1
The +141 is about 110v instead of 141vIt is recommended to replace the sops pwb (4822 212 23749).
PHILIPSFL1.1
Synchronization, picture disappearsD6703 and t7704 defective on picture tube panel.
PHILIPSFL1.1
Synchronization fault, "temperature drift"Change the value of r3132 (1k5) to 1k2 in high end box.
PHILIPSFL1.1
Stuck in stby switched from remote lights flashC2504 usually 1nf 2kv
PHILIPSFL1.1
Stuck in prot modeC2504 2n2 2kv, line shift trs 7512 & 7513
PHILIPSFL1.1
Stripes in picture.The following production change has been introduced to reduce stripes in receivers with serial numbers ag039143 or higher. position action old new(28") new(25") r3604 change 160k 120k 130k c250
PHILIPSFL1.1
Strange colors/phenomenas in picture (eg. green horizontal bands)Suspected problem in high end box. on fitting a new high end box, this cured the fault.
PHILIPSFL1.1
Strange characters after an hour.Ic7204 (pcf80c51bh; 4822 209 63903) in high-end-box defective .
PHILIPSFL1.1
Started but shut down with sby and stereo lights oTransistors 7542 , 7540 e.w. circuit
PHILIPSFL1.1
Spook in pictureUse special antenna cables. codenumbers: 4822 321 61224 pal 1 meter 4822 321 61225 pal 2 meter 4822 321 61226 secam 1 meter 4822 321 61227 secam 2 meter
PHILIPSFL1.1
Spook (interference and noise) in 100hz sets1. use special antenna cables: 4822 321 61224 pal 1m 4822 321 61225 pal 2m 4822 321 61226 secam 1m 4822 321 61227 secam 2m 2. add 2 capacitors o
PHILIPSFL1.1
Spare parts remote control rc64xxSpare parts remote control rc64xx --------------------------------- codenumbers for part of the rc64xx remote control: flap right 4822 432 92716 flap left 4822 432 92715 battery lid (cover) 4822 432 92714
PHILIPSFL1.1
Sound in pictureChange r3241 on lsp into 2,7Ω (4822 113 80584) remarks : this fault can occur in sets produced between week 9126 and 9132 when the set is used at high volume level.
PHILIPSFL1.1
Sometimes set switches off. no +141v.Por-voltage is about 8v. check d6272 (bzx55-b5v6; 4822 130 34173).