Search: Philips
Results: 14210

Philips Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS46PFL4908G
Tremendous pictureCheck the T-Com Auo plate,Remove R870, R872. R870, turn on with a thin wire to D802/3, turn on R870 to VGH voltage.Arock
PHILIPSNTX-600
Works but no audiotwo varistores on power supply one open, 80v low voltageReplace VR1 =20D241CARLOS
PHILIPSFWM570/19
Turns on everything works but no sound comes outDefective headphone recognition keytry to open the key to clean or replace itzordtech eletronica
PHILIPSNTRX300/78
Works but with display offShorted capacitor on display boardReplace capacitor ec302 position on boardAquiles
PHILIPS47PFL3007D/78
5V normal, sem 24V e 12VC703 shortedSMD electrolytic 220uF/16V C703 on the main PCB below the power supply connectorEderlin
PHILIPS47PFL3007D/78
5V normal, sem 24V e 12VC703 shortedSMD electrolytic 220uF/16V C703 on the main PCB below the power supply connectorEderlin
PHILIPS50PUG7406
Dead, no stand by. Arming the power supply, the voltages are all OKMain board with 2 capacitors shorting out next to a 4r7 coil close to the CN701 connectorRemove and check if the short has disappeared, then replace them. SMD Capacitors C4328 and C4322World TV - Sorocaba
PHILIPS 32PFL3404/78
When turned on, Standby lockedBroken trail at + do c474Remove the capacitor and jump from C340 to D1 up to the 3rd dot of the transistor u36 on the side that is not tsound next to C474 itself and solder a new C to make the job look good.Wilson
PHILIPS42PFL3403 42PFL5403 42PFL6403
Nothing turned on or stand byvisually: U101 (FSQ510) cracked with 1 melted pin / C236 ( CAP 2200mf 25v ) Swollen / R101A Torn (120 ohn resistor next to the main fuse) - all were replaced and the problem persisted, I analyzed pin 5 of the FSQ and measured , I found the ZD103 zenner diode broken (SMD under the board), I replaced it and the LED then came back on but it didn't activate the relay, I replaced the relay and everything started working againreplacedo: C236 / U101 / R101A / ZD103 smd / Relé RE1 12v- 250v10aGuedes Electronic
PHILIPS43PFG5813
No picture with screen \\\"washed\\\", LEDs onWith the right side viewed from behind, eliminate 8 trails on the left side of the flatToniTec
PHILIPS 29PT9467C
Sk5 1l ca
picture closed on the side, reduced frameDefect, replacement of cap c438, 272pf and cap L432 next to the flybackDj pituka
LG PHILIPS AOC43S5195 43S5295 43LJ5500 43PFG5813
Screen flickering lines on the screenreplace the displayI didn't find a cheap display, but I gave the budget based on one on the free market and it was approved, I'll leave the link for anyone who wants to buy it: External Link... KICO
PHILIPSMCM595
DOESN'T STARTC2217 DRYreplace itBARBADINHA
PHILIPSMCM595
stuck in standbydoesn't startreplacing capacitor C2217BARBADINHA
PHILIPS42PFG6519
715g6338-p01-000-002s
It doesn't turn on and sometimes the LEDs don't light upc9311, C9312, C9317, C9318, C9321 all 470x25v burst or with high esr if the LEDs do not light up it would be c9105 polyester mkp 0.022x1000v with cold on its pinsreplace all capacitors and resolder the board and look at the speakerorlando lott
PHILIPS50 PUG7625
No picture washed screenFlat cable right side from tcon to vconFlat cable right side solar sixth to tenth lineArtur
PHILIPS25PT848A/55R
L01.1L AA
No video input on AV 2 and side AV. I was also having audio problems. Right side very low and being connected to only one input, switching to the other inputs, the television continued to emit sound from the connected input.To solve the audio problem, replace HEF4052BT (7801). To solve the video problem, replace HEF4053BT (7802). Both are underneath the main board.Sígmar de Oliveira
PHILIPS 42PFL4908G/78
Does not turn on dead open fuseCapacitor in power supply c9803Replace capacitor c9803 and open fuse,UTI das tvs e microondas
PHILIPS42PFL3007D/78
42PFL3007D/78
DEAD STAND-BY 0V WHEN CONNECTING CABLE TO MAIN BOARD REMOVING BACK 5VSHORT IN HDMI IC (U501) DROPING power supplyREPLACING THE IC (U501) OR REMOVING IT AND LEAVING ITH. Guimarães
PHILIPSFWD789/55
Does not turn on, shows signal on displayQ906 short caused by glueGlue cleaning and component testingJunior de Conto