SEMP TV Repair: Common Faults and Solutions.
Search: SEMP
Results: 2824
Results: 2824
SEMP Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SEMP | LC-3246WDA LC | This TV was turning off by itself after 20 minutes, removing the back cover it worked for several hours without showing a defect. | Cause of the defect: damaged a/v-usb side plate, note: when removing the back cover, I also removed the a/v-usb cables, in short, I left the TV on but without connecting this board, replacing the board, the defect has been resolved. | Replacing the a/v-usb board | SÍLVIO SILVA ELETRÔNICA CARDOSO |
SEMP TOSHIBA STI | LE3250 (B) KPS+L070C2-01 | ST by LED flashing fast +b12v giving 6v | Replace transistor smd qb903 (2n3904) | And just replace and run for the hug | JOSE HUMBERTO F SANTOS |
SEMP | 32L2400 35019015-2014-01-17-REV-00 | Normal picture but no sound | Open coil l201, which feeds the sound output with 12v | MasterCell Eletrônica | |
SEMP TOSHIBA | 23L2400 OU 40L2400 | Tv nao liga so stand bay aceso | Check if the n805 is regulating 3.3v, if it is, check if tsound is 3.3v in the n807 because in the stand bay you cannot have this voltage if it is 3.3, directly replace the n801 and the TV works normally | N805 eco 3.3v in stand bay the n 807 can't have the 3.3v if it does, just replace the n 801 and run for the hug | beto eletrotec |
SEMP | TV2134 SK11 | The TV has an ok audio output and all voltages, but tsound is no sound. This version of the TV has the IC851 analog audio equalizer on the board near the varicap. | Ci defective equalizer, replace or if tsound is no other add the following components to the board (q801- brc1815,r804-470Ω,r739-56kΩ,r740-1kΩ) the jumper j801 and j802. | The TV returns the sound normally with the audio equalizer acting if the ci is replaced, if the modification is made the sound returns to normal (volume acting) but the equalizer no longer works... (tec, edfersom varjota-ce) | Edfersom |
SEMP TOSHIBA | 1451NAV U18 | TV turned on, but without sound and with the vertical trying to close at the top of the image. | Bad capacitors (in the audio the c613, 220uf/25v and in the vertical c308, 100uf/25v) | Replace with new or in good condition. If you don't have 25v, you can use one with a slightly higher voltage. After that, the TV will return to normal operation. | Tiago C. Neves |
SEMP TOSHIBA | DL3244 A W | Backlight on, no image | CD17 SMD shorted on display board. check the other capacitors nearby | Eletrônica Cecé. Brumadinho MG | |
SEMP | TV1030 U17 | Does not turn on, relay knocks and does not turn on, normal voltages and horizontal output heating. | Vertical output (q301 stv9302a) shorted. | Changing the vertical outlet (I put the la78040) after the replace tsound were some lines on the top, resolved by changing the c308. | J&M |
SEMP TCL | 32S6500S | Does not turn on, not even the STBY LED lights up. Source ok voltage only on D801 45 volts, LEDs tested all good, change regulator UD18 1.8v | In my case it was the reg ud18, it killed an input voltage of 3.3v and did not output 1.8 volts. | Davi | |
SEMP TOSHIBA | TODA LINHA U17 U17 | After switching on, image problems begin, colored waves, colored stripes, etc. | Electrolytic capacitor c528 next to the micro, and it took work to find out (put a 1uf/100v one) | Resolved | NILSON TVs |
SEMP | TV1452(O)AV U19 | It doesn't turn on, it's like a hissing sound in the power supply transformer | After a good search I found the q840 short | After changing it, the TV turned on normally | ASSISTEC MANARI-PE |
SEMP | DL4077 | Tsound is no image 12v and 30v ok Becklihg nvesor with 30v does not convert to 60v disconnected connected 51v | Dp15 diode defect near the mosfet power supply becklight dcdc | EletronicaArni L.Leal-sc | |
SEMP TOSHIBA | LE4056(C) F STI | The logo appears and the screen turns off, (not LEDs) | Resistor r742 1m | 1m resistor r742 and just replace | Eletrônica Garcia paraíso do to |
SEMP TOSHIBA | LE4058(C)F | Burning led. | High voltage/current. | Replace the LED bars and replace the value of the smd resistors r740 and r748 from 4r7 to 6r8 | evando viana |
SEMP TOSHIBA | LE3273A | The green standby turns on several times, but it turns back to red several times, and it only takes a lot of trying to turn it on. | Power supply board defect | Exhausted capacitors on the power supply board, c310 and 311 of 1000 by 25 volts | Galileu Rocha |
SEMP TOSHIBA | U18, U17 U18 U17 | Sound only goes up to 12 menu does not select function boxes | Enter service mode press the control sound once, release and press again and hold the two TV volume buttons together and hold for 5 seconds, | Save the service mode press s on the control once and release press the second time and hold and press the channel key going up and hold for 5 seconds the TV will turn off and restart and ready it is saved and configured. | |
SEMP | TV2959HFS LEM8 FS6 | Turns on with a line in the middle and turns off, vertically closed | Resoldar r311 resistor smd 3k ao lado do ic vertical | dj pituka | |
SEMP | DL 3944 | Flashing the screen and turning off | I will fall, I will stop, I will benefit from it | Replace each with 22μF/450volts | Multimarcas/Acarí |
SEMP TOSHIBA STI | DL3270(A)W | Does not turn on, LED does not light up | Does not provide 12v, 12v power supply with 2.6v | Transistor q305 2x smd with leakage, and the same transistor 1p | Center som |
SEMP | TV2051NAV U18 | It doesn't turn on, it makes noise and the power supply gives 45v | Non-secondary ceramic cap replace c865 103 | dj pituka |