Samsung TV Repair: Common Faults and Solutions.
Search: Samsung
Results: 3758
Results: 3758
Samsung Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG | 29M21MQ | League goes into protection | Resolder vertical c.i. check r816 and r821 (critical value 133k) | ||
| SAMSUNG | CB-5020Z - SCT11D SCT11D | B+ has 190v | R814(43r) interrupted.this resists. he is together with hc801 hybrid (his-0169c) power control. | Replace r814 | |
| SAMSUNG | CB 21H1T CHASSIS S15A | After a while there is no sound, image is ok | One of the speakers open replaces it, cold solders | ||
| SAMSUNG | CZ21A083N CH. KS1A | Image shifted horizontally, but the entire screen has image. | Had the cr405s disabled and the r414 open. | ||
| SAMSUNG | CW-28C73N CHASSIS KS3A | It doesn't work, the front LED doesn't light up | C511 na placa crt | ||
| SAMSUNG | CB3335Z CHASSIS P69SA | Without image and with return lines. | Ic de saída vertical ic301 ( ka2131 <=> an5512 ). | ||
| SAMSUNG | CB3335Z CHASSIS P69SA | Screen slowly darkens from right to left. The image is reduced to a small vertical strip on the left side. | In block f.i. diode d410 (1n4148) with small leakage. | ||
| SAMSUNG | CX-3312Z CHASSIS P-58SCP | Does not leave stby | Tsh in short 2sd1650, replace, electrolas at circ hor.com low capacitance | ||
| SAMSUNG | CB-5062A | The image gradually gets darker until you can no longer see it either via tuner or scart | Line transformer with cracks in the housing close to the screen potentiometer, replace it | ||
| SAMSUNG | CX5344N CHASSIS SCT12 | Yellow LED does not start | Disruptive r 812 caused by dry c815 | ||
| SAMSUNG | CX-5933 | Dash h | I.c. tda3654 w/defect. Once replaced the TV works normally but after 2 to 3 months the i.c. it breaks down again. cause c308 470uf/35v with low capacity. | ||
| SAMSUNG | WS-32A116V CH. K55A-1 | The TV turns on and off cyclically, the image sometimes appears, like a flash. | Replace diode d904 (rb441q), it was shorted. | ||
| SAMSUNG | CX-6844N | All voltages at the power supply output sometimes dropped by around 20%, leaving the image with little horizontal deflection. | Replacement for the 15v dz805, this one with a very small leak. | ||
| SAMSUNG | CB-5051A SHASSI: P68SA | Closed vertical and short on the sides | Q-806 ksc2331, +8v low voltage. | ||
| SAMSUNG | CB-3373T CHASSI S15A | Doesn't work | Check the power supply and output voltages and see if the 125v voltage is being lowered see tsh disconnect the line transformer pin or h_out and see if it normalizes and change the 271k 2kv c410 capacitor | ||
| SAMSUNG | WS-32W6HA CH. SCT53A | It starts with high voltage, but we only have video when the channel is changed, noticing that a color is missing. | The 82k r511 resistor was replaced on the socket board. | ||
| SAMSUNG | CX5944N CHASSIS SCT12B | LED always yellow, +b voltage around 70v, without mat | R812 (27r) open, connects to the q802 emitter | ||
| SAMSUNG | CX-6844N CHASSIS S51A-AA41 | The TV doesn't start with HT, the LED keeps flashing and the +b has around 200v | Had the r815 changed in the photocoupler circuit | ||
| SAMSUNG | CX-3318 CHASSI P58SC | Reduced image height | R308/18k | ||
| SAMSUNG | WS-32Z316V | Image all green. | R511, 542, 543, 506, 544, 510, all 160k, located on the crt plate, were replaced. |