Samsung TV Repair: Common Faults and Solutions.
Search: Samsung
Results: 3756
Results: 3756
Samsung Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CI3312Z | St/by only | No scl sda at pins 39 & 40 of micro ric01. rx01 10mhz xtal faulty | ||
SAMSUNG | CI3312Z | Oversized picture - set arcing over. | 125v at d821 high r807 ( 11k ) gone high. | ||
SAMSUNG | CI3312Z | No sound except thro' scart | Ic601 cd4066bcn sw chip faulty | ||
SAMSUNG | CI3312Z | No sound | R709 27k which feeds ident signal to pin 29 of micro ric01 o/c | ||
SAMSUNG | CI3312Z | No signals | No 33v at collector of rq04 - rr05 10k ¼w o/c | ||
SAMSUNG | CI3312Z | No search tuning - tuning rail stuck at 30v | Rq01 dry | ||
SAMSUNG | CI3312Z | No search tune - tuning volts stuck at 29.5v | Dry joint rq01 | ||
SAMSUNG | CI3312Z | Needs degaussing repeatedly | Remove plug + socket on coils | ||
SAMSUNG | CI3312Z | Lack of height | R302 470k hi res | ||
SAMSUNG | CI3312Z | High ht blows resistors in lop stage | R807 11k had increased to give 157v ht instead of 125v at d821 | ||
SAMSUNG | CI3312Z | Dead | R801 5r6 o/c, q801 bu508a s/c, c816 split & check c811, 808, 817, 813 & check for dry joint on p802 | ||
SAMSUNG | CI3312Z | Dead | Check for dry joints r823 in 12v reg feed & r411 across pri line driver trfmr | ||
SAMSUNG | CI3312Z | Colour int lost | X501 8.8mhx xtal - to set up short pins 1 & 6, 21 & 22 of ic501 & adj cv01 for floating pic | ||
SAMSUNG | CI3312Z | Arcs then goes dead . r412 overheats , ka2131 sc . | Remove frame ic and check ht , if high ( should be approx 110v/120v ) r807 11k high in psu | ||
SAMSUNG | CI3312Z | Arcing then dead | Ht low at 70v - r412 overheating, fop chip ka2131 leaky, ht now high at 180v - r807 11k hi res | ||
SAMSUNG | CI3312 P58S | Lack of hieght | R302 ( 470k ) if ic ok | ||
SAMSUNG | CI3312 CI5013 P58 | High ht on b1 ( 125v ) line , causing q402 to fail | Check r807 ( 11k ) pt no. samsung 31018177113 - reason : no ip. on pin 3 ic801 for control amp | ||
SAMSUNG | CI3312 | Tuning info lost on channel change and set needs r | Pcd8572 ric02 us | ||
SAMSUNG | CI3312 | Tuning drift | Check r124 33k, r116/rr26 120k in afc cct - should be 2.5v at pin 9 of micro ric01 when afc locked | ||
SAMSUNG | CI3312 | Tuning drift | R124 33k r116 , r126 120k |