Semp TV Repair: Common Faults and Solutions.
Search: Semp
Results: 2824
Results: 2824
Semp Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SEMP | TV2959IFS | When turning on, blue screen and then turns off. | The cause could be the computer, but I just turned off the d625 and it worked perfectly again | ||
SEMP TOSHIBA | TVC102CR | Manual tuning doesn't work - aft inoperative | C104 and c172 swap | Rubens | |
SEMP | TV1484 | White screen, no characters | Epron truck | Die-a | This email address is being protected from spambots. You need JavaScript enabled to view it., jaicós PI |
SEMP | TV2051NAV U18 | Led do stand by piscando | Trt.horizontal exit and width cap.7n8 1k6 | luiz g.silva | |
SEMP | TV 1492LAV U 16 | Q 430 heating up and turns off the TV | D 448 exchange directly without testing | eddye | |
SEMP | TV1460E | Has all tensions and does not oscillate | Open 39k resistor819 | Eletroclaudio Aguas Belas PE | |
TV SEMP | 1483BAV | Doesn't start | The TV arrived with the power supply broken, the strf was burned out, r875-0.24, r860-100k, r861-560k, d876-5.6v, I changed everything and connected it to the series the power supply was normal, but when I plugged it directly into the socket everything exploded again | I started everything again, I replaced everything once again, but I corrected the power supply down to the smallest detail, and with a lot of effort and a lot of desire to give up, I found the r 876-860Ω (SMD) open, I replaced the TV and it worked normally. | BF.COLATINO |
SEMP TOSHIBA | 2085FM | Very open vertical | I found the c884- 22uf/160v dry, I replaced it and it worked normally. | BF.COLATINO | |
TV SEMP | 2959HFS | With buzzing and clicking noises near the main transformer | Short on c306-2200uf/25v | Resolved with replacement. | BF.COLATINO |
SEMP | TV 1492 LAV | Image sometimes light sometimes dark | Dear colleagues, the defect was the capacitor. 1k for crt card. | BF.COLATINO | |
SEMP | TV1451NAV U18 | Vertical closed and there was no vertical exit | It was a cold solder on the 15r resistor r421 | Resolder | Eletroclaudio Aguas Belas PE |
SEMP | TV 1460 E | Image with shadows on the left side of the screen | Wear of parts | Capacitor 447 10mf 250v | Francisco Ivan Basílio - Nova Eletrônica - IBIARA-PB |
SEMP | 1460 E | TV with image out of focus | Tube socket | IVAN - Nova Eletrônica - Ibiara-PB | |
SEMP | TV 1491 K | LED lights up but the TV doesn't start | Capacitor 419 47mf 50v | Capacitor 419 47mf 50v | Francisco Ivan Basilio - Nova Eletrônica - Ibiara-PB |
SEMP TOSHIBA | 1482EAV U7 | Stand by light on but not working image | Transistor q430 solder free | Resolder the same | Rogerio silva |
SEMP | TV2987 | Tv with/ channels locked with/ password | I didn't find a default password, reading the manual I discovered an e-prom reset. enter service mode, when in service mode press key (s) and ch + at the same time, keep pressed until the TV turns off. Then just run auto-programming. | Tecnardi | |
SEMP TOSHIBA | TV1484 | Does not turn on LED stays on | C872 35v 33uf electrolytic capacitor | jefersonpierini | |
SEMP TOSHIBA | TVC 102 | Doesn't start | Transistor 2sa1320 (q813) power supply board shorted base emitter | Responsible for powering the IC responsible for the horizontal output | Fernando Siqueira |
SEMP | TV2070F | Vertical closed at the bottom | 2.2uf 50v capacitor next ci oscillator | Replace | willnner |
SEMP | 20 U8 | Bad contacts sometimes turn on and sometimes off | Cold welding in the infrared of the remote control | joao ortencio |