Semp TV Repair: Common Faults and Solutions.
Search: Semp
Results: 2824
Results: 2824
Semp Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SEMP | TV2934 SKY | Knocks relay but doesn't turn on | R604=2k2 open | I replaced and ran to another one | Antonio Carlos (Eletrônica Renascer) |
SEMP | TV2134 | Does not turn on LED does not light up | +b zero was shorted in the str and in the photo coupler | After changing str and photo coupler +b it was low 60v I found the q 605 and q606 shorted. | Center som |
SEMP | 48L2400 | Turns on with logo and turns off backlight | LED lights up, but it's defective | I quickly tested all the LEDs and found only one open, all the others lit up. When I finished the replace, I turned it on and the defect still persisted, but I noticed that tsound was a light flickering (trembling), I placed cardboard covering the bars so that I left only one of the bars exposed, I tested them all and discovered the bar that was shaking the lights. I short-circuited it with a wire isolating the LED from the LED and I found an LED that caused the defect and the damn thing lit up, strange, but it lit up and with the direct test I hadn't noticed it because I only touched 6 volts, it lit up quickly and I went on to the next test. A tip to keep an eye on, you waste a lot of time researching these cocks. hug! alex nardi | Tecnardi |
SEMP | 2934 | Totally dead | It only had 174v on pin 1 of the trw5665a, it came back replacing the zd602 18v, tsound's no point in measuring, replace directly! | eletronica fenix | |
SEMP | 20 14UR | Vertical closing from bottom to top | Q 430 | Replace the same | marttinho eltronica |
SEMP | LC4055 | Blinking LED does not turn on | Changing the 12 and 24v l659 power supply controller circuit | Changing the 12 and 24v l6599 power supply controller circuit | JEFITE ALVES |
SEMP | LCD 3246 | Turning on and off | Cold soldering | Reballing | Hdsat eletronica |
SEMP | TV2134 | The on and off signal keeps restarting, if it increases, the screen appears vertically closed | Capacitor c329 diodes d305 and d306 with problem | Replace of c329 d305 and d306 | ELETRONICA KLEIN |
SEMP | TV2934BSL | It didn't turn on but the LED blinked | Replace o c634, c311 e c329 | Replace them and run for the hug | Wildes (eletrônica Santa Luzia) |
SEMP | 2134 | Totally off | C613 of 1000n by 2kv and the primary power supply fuse | After changing them, the TV started working again | AssisTec |
SEMP | TV2134 | TV with green image and retrace lines | Q-509 leaking | I replaced and ran to another one | Antonio Carlos (Eletrônica Renascer) |
SEMP | 2134 (B) | Switching on and off, with +bs voltage changed | 220k r633 open | Changing the 220k r633 and the TV was ok. | Rdo Antônio Acre |
SEMP TOSHIBA | LC320... | Does not turn on, verified that 12 and 25 volts do not come out of the traffic. | Photo coupler near the defective transformer. | It was replaced and it solved the problem | Rodrigo |
SEMP TOSHIBA | TV 2999 LEM8 | Turns on then turns off. | Corrupted memory | Replace the micro memory ci | GUINGA sdia - goias |
SEMP TOSHIBA | TV2922IFS LM9 | STBY LED lights up but the secondary power supply does not go above 60v +b | Solution to change q852 njm431 and for hug | josecarlosdss | |
SEMP | TV 1460 | Vertical closed only at the bottom | C304 e r312 | Replace 07/02/2018 | FLAD8 |
SEMP | TV 1454 (P)SL | Vertical closing and with retrace lines at the top | D401 | DELFONSO DS ELETRONICA AFRANIO-PE | |
SEMP | LC3246WDA | Reset | Reset | With the TV remote press menu the menu appears on the screen press the numbers 2008 choose the last line reset fáctoy | TECMIX ELETRONICA |
SEMP TOSHIBA | LE4050 | TV appears soon and turns off backlight, LEDs ok inverter board ok | Defect generated by open capacitors at the power supply | Replacing capacitors at the power supply | willian |
SEMP TOSHIBA | TV2159 U19 | Working but the r442 is frying. | R442 heats up quickly. | Replace the c442 of u22 or u27 with one of u43. | Elias2305 TO. |