Semp TV Repair: Common Faults and Solutions.
Search: Semp
Results: 2824
Results: 2824
Semp Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SEMP TOSHIBA | TV2134 SKY | Sometimes it turns on and off and on | Q-606 | ELETRONICA INFOAÇU | |
SEMP | TV2134 SKY | Image distorted and slightly reduced on the sides | Cap. c-311 47/160v | ELETRONICA INFOAÇU | |
SEMP TOSHIBA | TV-2934SKY | Does not turn on, then hissing at the power supply, then yellowish image. | The TV did not turn on nor did the stand by LED light up, the ci601 strw6556a voltages were all at 0 volts with the exception of pin 1 which was at 174 volts. checking the circuit I found r603 68k was open, this resistor feeds the ci601, so I replaced it and the ci601 started working again, however the LED kept oscillating, increasing and decreasing its brightness and at the same time a hissing coming close to the traffic, the image it was normal, I then replaced c311 47uf/200volts (133volt filter capacitor that feeds the horizontal) then the LED stopped oscillating and the hissing also stopped, then I left the TV to test, after a few minutes on the screen turned yellow (image appeared normal but yellow predominated in the scenes). I refitted the solders on the tube plate and also on the ci201 wsound the video signal comes from, but without success, I gave the pins of the tube wsound the socket fits into it a good clean, as they had a darkened tone, when cleaning with a I fitted the socket into the tube with water sandpaper and the image was perfect. | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
SEMP | TV-2090 U14 | This TV had the LED blinking as if it were the horizontal output, but in fact it was the 180 dry capacitor, it was just replaced and it worked normally | C446 4.7 250v replace | ||
SEMP TOSHIBA | TV 2157 | Retrace lines only at the top of the screen | C 308 , 100mf/35v | Alextecnico | |
SEMP TOSHIBA | 2083BAV U10 | Vertical closed deflection | Screen does not open | eli | |
SEMP | 2051NAV U18 | White lines at the top of the screen. | Check c308 or d301 changed. | jayjunior | |
SEMP | TV1490 U14 | Warming up horizontal output, replace the electrolytic capacitor c419 47uf 50v | C419 47uf 50v | joãotc | |
SEMP | TV1490 U14 | Lights up stand but doesn't fluctuate 180v voltage was reducing to 95v replace q406 had a short between the bass and emitter | Replaceo q406 | joãotc | |
SEMP | TV1490 U14 | Horizontal output heating up to the point of burning replace electrolytic capacitor q406 47uf 50v | Warming up horizontal output replace electrolytic capacitor q406 47uf 50v | Electrolytic capacitor q406 47μF 50v | joãotc |
SEMP | TV1492LAV U16 | Heating the horizontal output and after a few minutes it burns, replace the 74uf 50v capacitor c440 | C440 | joãotc | |
SEMP | TV1492LAV U16 | Burning horizontal outlet | Capacitor change = c414 | joãotc | |
SEMP | TV1492LAV U16 | Insufficient vertical | I saw in the tips found on the internet that it would be the q430, I didn't even test the old one, I put a new one straight in, but the TV didn't turn on anymore with the new part. | I decided to test the old q430 and it was shorted, I found the d431 (zener 10v) shorted too, I put the new q430 in and replaced the d431 and it worked normally, even the vertical one opened | Ailson |
SEMP TOSHIBA | TV 2091 U14 | TV with upright partially closed both at the top and bottom. | Resistor r317 with changed value. | João | |
TV SEMP | TV 2090 U14 | Strw 5753 power supply regulator burns | D 876 shorted | Amadeu | |
SEMP | TV 2090 U14 | D876 short burns strw 5753 | Replace d876 zener 5,6 | Amadeu | |
SEMP | TV2090 U14 | Does not work, only stan-by LED on, +b 76v power supply | Power supply capacitor c887 low without capacitance. | Replace c887 without measuring | ALEX/FETTER |
SEMP | U16 | Just stanby without the (hvcc) | Zener diode d431 shorted | Bruno nicacio | |
SEMP | SD5091VK 919242 | Does not turn on, standby LED blinks | We1 position capacitor with value 100uf x 16v | Replace the capacitor with the same or equivalent one and run for the hug! | Wanderlei Studio - Eletrônica Áudio e Vídeo - Quixadá / Ce |
SEMPTOSHIBA | TV 2157 (B) FS LEM 7 | It works from time to time when it goes offline and destabilizes the horizontal, vertical and chroma. you turn it off and on and it works normally | Replace zener diode d101= mtzj33b or 33volt zener and cap.elet. 112=4.7x50v. it's ready! | Dé andrade | Dé Andrade |