TV Repair: Common Faults and Solutions.
Search:
Results: 87436
Results: 87436
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | XR6500 | Rew/ff knob falls off | I have had three customers call that have this unit that com-plain that the ff/rew knob comes off when they pull it to perform ff/rew. | ||
SONY | CDP701ES | Apc adjustment procedure | The attached fpr from 10/23/85 (not in computer) indicatesthat it would be issued on how to adjust the laser output but i cannotfind any such service bulletin or supplement etc. was this ever issued?what is the adjustment procedure? -hq comments: when | ||
SONY | TAAX520 | Right channel out | When the bass control is turned up, the right channel will cutout. | ||
SONY | EVC3 | No power and does not work | No power and does not work. | ||
SONY | EVC3 | Unit loads as power is applied | When power is applied unit loads automatically. no output signal from a-301 or q-302. | ||
SONY | CCDV9 | Shutdown dew indication and eject mode activation | Unit stayed on eject position and dew indication at all times.as soon as power was turned on, found the contact pins in connector cn-001of flexible ribbon fp-57 having poor pressure (preventing good contactwith terminals at cc7 mechanism board). | ||
SONY | CFS903 | Function button does not lock in position | The switch will not stay in position due to the elasticity ofthe rubber cover on the switch. the rubber is so stiff that the switchis forced back to its center position. -hq comments: tokyo fax (a900272): an improved rubber cover (ref #61)has been mad | ||
SONY | CCDV11 | Tg-1 arm falls out | Bushing that holds tg1 arm onto chassis falls out. thechassis that would include this bushing is not supplied (see included copyfrom service manual). i am forwarding the arm and bushing just the way itwas found in the unit. several ccd-v11s and ccd-tr | ||
SONY | ITA850 | No audio from speaker in speakerphone mode | When in speakerphone mode, there is no audio out of thespeaker. you can hear the dtmf tones when dialing on line. | ||
SONY | CCDV9 | Unit dead fuse blown | Unit would intermittently blow fuse f-902. | ||
SONY | KV27HSR10 | No picture sleep light on,replaced c-500 | Set has high voltage. sleep light is on, but set has nopicture. found .7vpp on pin 31 of ic-301 (should be 2 volts). replacedic-500 and ic-301 still not working properly. found shorted c-500. -hq comments: when c-500 located on ic-500pin 1 shorts, | ||
SONY | CCDTR5 | Tg-1 arm falls out | Bushing that holds tg1 arm onto chassis falls out. thechassis that would include this bushing is not supplied (see included copyfrom service manual). i am forwarding the arm and bushing just the way itwas found in the unit. several ccd-tr5s and ccd-v1 | ||
SONY | CCDF35 | No rewind, record or stop functions | No rewind, record (vtr), or stop functions. | ||
SONY | KV32XBR70 | S.r.s problem, install new srs module, see s/b 0045 | Audio buzz when s.r.s is activated. customer is using anantenna not cable. | ||
SONY | ITA850 | Answer mode 1 does not work | Answer mode 1 does not operate. | ||
SONY | ICF2010 | Weak am | Very weak am reception. when you touch rod antenna with hand,reception came in normally. | ||
SONY | CDP470 | When disc is loaded, display reads no disc | When disc is loaded, display reads (no disc). replacedoptical pickup, which usually causes this symptom, but that did not work. | ||
SONY | STRAV340 | Speaker terminals | Need part number for speaker output terminals. -hq comments: the speakers terminals are listed under the terminalnumbers in the service manual on page 33. the number is tm-901,1-536-706-00. | ||
SONY | STRAV910 | Unit in protect | Unit in protect. amp o.k., drivers, pre-drivers, etc. | ||
SONY | SLV555UC | Unit tries to unthread beyond normal stop point - jams tape | Unit may evidence various symptoms, including tape jamming, noplay, emergency shutdown, etc. |