beko Repair Tips
Search: beko
Results 113
Results 113
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Beko | 30128T | Dead & ticking | BU508DF LOPTr s/c, C140 22n 630v o/c | ||
Beko | 30128T | Dead - LOPTr blown & twitching/flashing when replaced | R149 Surface mounted resistor should be 1K5, was up to 41K | ||
Beko | 2841ND - 14.1 chassis | Lines across top 3 - 4 inches of pic | R422 35v feed to IC501 fop chip never been soldered | ||
Beko | 2832T | Pic takes a long time to appear | R213/4/5 22k on crt base or LOPTx | ||
Beko | 28328NX | Nicam drop out | Reset variable cap C678 for 2.8v at pin 1 IC603 | ||
Beko | 2812NX | Field scan partially missing & no tuning | R200 o/c (4R7) and IC200 TDA8170 S/c | ||
Beko | 28128NX 11.1 | Dead aft smoke | LOPTx u/s 058.541-TR1 R118 10k 0.5W in beam current sensing burnt R110 4.7R 0.5W fusible o/c in +200V supply | ||
Beko | 28128NX | Dead & tripping psu | S/C BU508DF LOPTr - when replaced int width variations - caused by wire on Line Dr Trfmr not soldered | ||
Beko | 28128 11.1 | No video via scart | TDA8361 | ||
Beko | 25411ND | Bright raster with sound | Pic can be restored by altering A1 or Focus control - CRT faulty | ||
Beko | 20320T | Field collapse with rainbow effect | replace ESM740 thyristor - new type requires a 47 ohm resistor from gate to source. | ||
Beko | 20320NX | Sound pops when vol adj | IC601 TDA6610-5 | ||
Beko | 20320NX | No Tuning Menu | Reset micro - Press & Hold P+/P- on set & sw on. Set comes on in service mode - then sw off | ||
Beko | 20320NX | Line tearing at top of pic | 220R resistor across scan coils o/c | ||
Beko | 20320NX | Field scan non lin - stretched at top | 220R resistor across scan coils | ||
Beko | 2030T | Rapid tuning drift | R61 27k 2w | ||
Beko | 20306NX | Dead - MOSFET 2SK1118 s/c | Only works short time aft replacement - chopper tfmr faulty | ||
Beko | 20230T | Diagonal white/black lines across the top 6-7 inches of the frame. | 220 ohms res , o/c or high res , mounted on the scan coils. | ||
Beko | 19221NX | No mono sound | C214 150pF in IF can | ||
Beko | 17125T | Severe E-W bowing | lopt 11.1,110 CPC TFHR8007 |