jvc Repair Tips
Search: jvc
Results 369
Results 369
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
JVC | C21M3EK | Line freq off & lack of field bottom scan | R421 0R68 risen to 5R | ||
JVC | C21M3EK | Dead | C910 0.1µ | ||
JVC | C21M3EK | Bottom cramp, no col, pulling, warbling sound | Low 12v supply (9v) on D405 - R421 0R68 hi res | ||
JVC | C21ET1EK | Contrast poor | R318 100k hi res | ||
JVC | C2155EM | Slow start up | C13 & 33 220µ in st/by cct low cap | ||
JVC | C210KM | INT. SWITCHES TO STANDBY | D507 , D508 , Q508 , Q509 | ||
JVC | C210EKY C210EKY | Focus - out of focus | If focus control adj A1's LOPTX faulty. | ||
JVC | C210EKY | Poor Focus | LOPTx replaced | ||
JVC | C210EKY | Int luminance | Hairline crack in print pin 18 IC201 col decoder chip | ||
JVC | C210EKY | Dead | STR54041 chopper chip or C913/917 | ||
JVC | C210EK | No sound | Crack in print by audio/IF sub panel | ||
JVC | C201EK | St/by only | Replace SBX-M904A Station Select Module £39.78 + VAT from WVE & C913, C914 and C917 in PSU | ||
JVC | C201EK | Dead with squeal from psu | Replace Q551 2SD1427 s/c LOPTx, Q923 2SD1274 s/c, D929 15volt Zener s/c, IC 901 STR54041 & R919 390K & R905 330K slightly hi res | ||
JVC | C14ET1K | No col & reduced height | 12v supply low R434 (6R8) hi res | ||
JVC | C14ET1EK Onwa | Rapid tripping at sw on | C402 4n7 500v leaky in prot network | ||
JVC | C14ET1EK Onwa | Dead tho' st/by relay operates | Supply of 8.5v to IC301 pin 42 missing - R323 6k8 5w o/c | ||
JVC | C14ET1EK Onwa | Col goes aft 5 mins | Pin 12 IC301 AN5601K low at 2v (5.1v); C325 0.47mf 35v tant was fitted wrong way round | ||
JVC | C14ET1EK (Onwa) | Dead | C909 47µ had exploded & perlace C911 47µ 50v. No Ht when replaced - R404 1R0 safety res o/c in 16v supply | ||
JVC | C14ET1EK Onwa | Wriggling line at bottom of pic (after repairing blow up) | 12v line low at 11v - fusble res R434 0R68 had risen in value | ||
JVC | C14ET1EK Onwa | Sync crushing with soot & whitewash pic | C113 |