sanyo Repair Tips
Search: sanyo
Results 351
Results 351
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Sanyo | CBP2146 | Negative picture on small insert. | QC0905A/3052v 5v reg. | ||
| Sanyo | CBP2145 E2-B21 | FIELD JITTER AND OR PART FIELD COLLAPSE | C364 C398 100uF 25v | ||
| Sanyo | CBP2145 E2 | TUNER SEEMS LOW GAIN FOR 10mins | C397 364 10uF 16v | ||
| Sanyo | CBP2145 E2 | Signals noisy with lack of height | C397 100µ 16v | ||
| Sanyo | CBP2145 E2 | POOR PICTURE WHEN BRIGHTNESS TURNED UP | C364 100uF 16v OC | ||
| Sanyo | CBP2145 E2 | Picture break up & bad twitching. | Replace C364 ( 10uf , 16V ) | ||
| Sanyo | CBP2145 E2 | No start up | D331 opto had slight leak | ||
| Sanyo | CBP2145 E2 | No sigs for first 10 mins & only chans 3 & 4 selected | Ripple on 5v supply - C395 100µ 16v | ||
| Sanyo | CBP2145 E2 | No sigs at sw on - ok when heated | C397 & C364 10µ 16v | ||
| Sanyo | CBP2145 E2 | No signals | Check L391 coil which supplies 5v to tuner - can be int | ||
| Sanyo | CBP2145 E2 | LOSS OF SIGNALS | L391 5v SUPPLY TO TUNER. CAN REPAIR THEMSELVES AS SET WARMS UP. | ||
| Sanyo | CBP2145 E2 | LINE PULLING + BUZZING FROM COLD | C364 100uF 16v | ||
| Sanyo | CBP2145 E2 | Field collapse | Dry joints FOP stage & check 10µ 25v caps in this stage | ||
| Sanyo | CBP2145 E2 | Field - partial collapse, no sound & shaky pic | C346 & C398 100µ 25v in psu | ||
| Sanyo | CBP2145 E2 | Arcing noise and flashing pic for first 10 mins or line tearing on high brightness scenes | C364 100µ in 12v supply | ||
| Sanyo | CBP2145 | Poor pic until heated | C364/395/397all,[100mf 16v] C396,[470mf,16v] C398,10mf,16v] | ||
| SANYO | CBP2145 | PATTERN ON SCREEN AFTER 1 HR | REPLACE C364 AND C398 100MFD25V | ||
| Sanyo | CBP2145 | One colour dropping out. | Resolder transistors & edge connector on CRT base. | ||
| Sanyo | CBP2145 | No sync | D1010 5v zener | ||
| Sanyo | CBP2145 | Interference lines on picture | IC361(LM7812 |