sanyo Repair Tips
Search: sanyo
Results 351
Results 351
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Sanyo | CE28WN5 EB6-A | Sound int | check dry joints IC801 main micro sm | ||
| Sanyo | CE28WN4B | St/by only with LED flashing | R620 120k hi res | ||
| Sanyo | CE28WN4B | Int Cuts out with LED flashing (prot mode) | To disable prot mode dis R648 - after a while crt heaters went out due to dry joint | ||
| Sanyo | CE28WN4B | Excess height & E-W faulty | Fit mod kit B10H04N1C or B10H04D0L if Dolby Pro Logic set | ||
| Sanyo | CE28WN4 EB6A | Excess width & no E/W after LOPTx replacement | D469, C463 (10nF 50V) and Q462 (used a 2SD1207),C465 (33nF 50V) and D463 both s/c | ||
| Sanyo | CE28WN4 | St/by only shortly after fitting B10H04NIC mod kit | IC802 the PROM which is part of the kit was faulty | ||
| Sanyo | CE28WN4 | EEPROM Problems | There is a mod for this set, part No B10H04NIC the micro doesn't get enough info on shutdown and reverts to default values, hence very big pic! Service mode is accessed by pressing the green button on the remote followed by prog down on the set. | ||
| Sanyo | CE28FWN2 | Dead - 4A internal fuse o/c | Replacement brought set to life - no other fault found | ||
| Sanyo | CE25DN5 (EB6a Chassis) | To enter option mode | hold the F/OK button on the r/c and press the P -(down) on the tv. Highlight the desired option using the P +/_ button. Vol +/- to change option selected. To exit press the recall button. | ||
| Sanyo | CE25BN2 EB4-A25 | No pic - HT only 125v (150v) - sound present | Diss any of secondary supplies corrects HT. When Q611 and Q612 and D617 in psu pri removed for testing & replaced cures fault! | ||
| Sanyo | CE21DN3B | Dead with led flashing | R624 120k o/c also check R620 120k | ||
| Sanyo | CBT2146 | Txt corrupt | IC1031 SAA5240A | ||
| Sanyo | CBT2146 | Poor sync | IC1011 SAA5230 | ||
| Sanyo | CBT2146 | Pic fades aft sw on | dry joints R479 | ||
| Sanyo | CBT2146 | Lack of width & field foldover when heated | C310 0.047µ 50v | ||
| Sanyo | CBT2146 | Int red pic | Dry joints A602 on crt pcb | ||
| Sanyo | CBT2146 | Corrugated verts | EHT lead conns | ||
| Sanyo | CBT2146 | Bright raster with fb lines | R478 10R o/c | ||
| Sanyo | CBR2148 | Replacement of TDA4505M - NLA | Use TDA4505E & change R136/121 to 470k & adj AFC as nec | ||
| Sanyo | CBP5156 | No chan OSD, vol bar stops ½ way across & no B in Txt | Dry joints IC001 SAA5246 Txt proc chip |