32PFL3018 TV Repair: Common Faults and Solutions.
Search: 32PFL3018
Results: 10
Results: 10
32PFL3018 Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILLIPS | 32PFL3018 | Stby lit, after a while lights backlight, erases and returns to stby. | Defective memory. From to \\\\ force \\\\ the TV to turn on when it ascends the backlight disconnect the cable from power supply to main and connect again, with the TV connected to the plug normally. | In my case it worked, but perhaps the ideal is to replace the memory, I will leave test a few days to make sure it will be necessary to replace my memory or not. | Pedro Igor - Eletrônica Portugal |
| PHILIPS | 32PFL3018/78 | TV doesn't turn on | TV TURNES ON BUT STAYS ON STANDBY FLASH MEMORY WITH COLD SOLDERING OR REPLACING U04 MEMORY | Fixing the welding defect solved the problem. | DINIZ16 |
| PHILIPS | 32PFL3018 | Turns on, with audio, without video. If you light up the screen, you can see that tsound is video, the back light is off | Check the power supply connector, pin yes, 0.4v, it has to be around 1.8v. | Check, replace q703 next to connector cn701 | Arock |
| PHILLIPS | 32PFL3018 | After recording the memory or exchanging it, the image was inverted | 062598, little house, 034, ok | HP ELETRONICA | |
| PHILIPS | 32PFL3018D/78 | ONLY turn on the backlight with the red standby LED on steady, then turn off the backlight and standby remains on. | Corrupted flash memory. Go to the website https://microtecpg.com.br/philips-memoria-flash-e-esquemas-eletricos/ and download the data from the memory corresponding to the television display. In my case it was just re-recording another memory because hers was corrupted, it worked perfectly. | EC | |
| PHILIPS | 32PFL3018D | After changing the memory, the primary colors on the screen alternate. | Burn adjustment | With the TV on, type on the remote: menu, 1999, return. locate "burn in" and switch to off. | Persio (TVCompany) |
| PHILIPS | 32PFL3018D/78 ENVISION | When changing the main board the image was inverted. | The mainboard memory was from tpvision | I entered the code on the control, 062598 + home(menu)+164+ok, the TV turns off and on with the normal image, I didn't need to enter service mode | Geraldo de Petrópolis, RJ |
| PHILIPS | 32PFL3018D/78 | The tuning was bad, with a distorted image on all channels | I downloaded the drivers from the Phlips website and reinstalled them on the TV. | Rosana | |
| PHILIPS | 32PFL3018D | Does not turn on, backlight comes on for a few seconds and goes off, standby remains red. | Epromm with cold solder. | Remove and replace eprom with new solder, remove old solder with desoldering mesh. | Antony Garcez |
| PHILIPS | 32PFL3018D/78 TPS10.1L LA | Inverted image | After changing the flash memory, the image is inverted | Enter the code via the remote control: 062598 + home + 034+ ok | leitemarcellus |