TOSHIBA C7S Repair Tips




Search: C7S TOSHIBA
Results 17
MakeModel Ch.SymptomProblem SolutionSolutionBy:
ToshibaC7SS 28W93B
int. line whistle in widescreen modeL441 (23233090)
ToshibaC7SS 28W8DB
stuck in stbyQ4370 (B0385853)
ToshibaC7SS 28W8DB
height reducing/varying, may be distorted sound with patterning on picC892 2200uF 35V 105deg on power PCB
ToshibaC7SS
White diagonal dashes - depends on vi contentTA9090AN digital comb filter chip
ToshibaC7SS
Thin hor white line over picMove C314 to print side of pcb - see diag in Serv briefs
ToshibaC7SS
background hiss from rear spkrsimproved Dolby digital module reqd
ToshibaC7S
partial field collapseC323 connected to pin 2 of Q501 leaky - 0ยต68 50v plastic
Toshiba3377DB C7SS
Hiss from left/right chan at vol level 1Replace Multiplex/Audio module H002 type MVGS48 pt no 23148275
Toshiba28W93B C7SS
St/by only with LED litHT only 43v - IC Z801 HIC1016 u/s (HT regulator IC,12UKP+VAT). HT must be 125V when on & about 60V in standby
Toshiba28W93B C7SS
St/by only - HT only 43v (125v)IC801 HIC1016 faulty
Toshiba28W93B C7SS
Line speed slightly off causing hor linesC508 12pf in series with Xtal relaced
Toshiba28W8DBA C7SS
St/by only with R & G LEDs flashing - was orig int start updry joint on (+9V-1) reg tr Q420on sigs board next to IF unit. Overriding the protection by unsoldering pin 16 of Z801 broght the set to life with a narrow frame collapse 3/4 of the way up the screen
Toshiba28W8DB C7SS
Field collapse - no drivereplace e/w ic Q4370 TA1241 pt no:B0385853
Toshiba28W8DB C7SS
Dead with plug mains fuse o/cReplace Q801 STRS6709 pt no 23905084, bridge rect D801pt no 23316795, zener D804 MTZJ6.8B pt no 23316678, zener D815 MTZJ15B pt no 23316725 & R810 3R 15w pt no 24007864
Toshiba2877DB C7SS
Reverts to st/by aft init EHT with G LED flashingFrame IC Q301 TA8427K s/c on pin 2 (scan output).
Toshiba2877 C7SS
Dead - HT low at 60vQ801 STRS6709 - also replace D809, D813, D804
Toshiba2873DB C7SR
No sound - corrupt eeprom set system to 5.5MhzFit new eeprom from Tosh aft reprog it