HBTV-32D05HD TV Repair: Common Faults and Solutions.
Search: HBTV-32D05HD
Results: 32
Results: 32
HBTV-32D05HD Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| HBUSTER | HBTV-32D05HD | Input function and menu does not adjust | The lock function has been placed preventing the entrances replace. They have to enter the lock function by the H.Lock key on the CR and disable lock | ELETROFEPAR | |
| HBUSTER | HBTV-32D05HD | In stand by the power supply becomes high and the capacitors are damaged. | When replacing the 470uf capacitors, also replace the two 47ufx50v capacitors in the power supply primary. | Ricardo | |
| H BUSTER | HBTV-32D05HD | Flashing blue stand-by light, power supply pulsing 5v | Open d31f that powers the primary ci driver. | Replace it with a 1n4007, pay attention to the fact that on the cathode side (white band) tsound is a ferrite ring underneath the glue. | Eletrônica Barbato |
| HBUSTER | HBTV-32D05HD | Turns on standby and does not turn on | Q 6 open | Replace q 6 | ON-PLAY ELETRONICA |
| H-BUSTER | HBTV-32D05HD | Does not turn on, no standby | Power supply board: replacement of shorted z6f zener diode and swollen capacitors | OlimpioF | |
| H-BUSTER | HBTV-32D05HD | Blue LED turns off but doesn't turn on. screen goes black, no backlight | Rewrite u3 chip (eprom memory) | Eletronica Jambeiro | |
| H-BUSTER | HBTV-32D05HD | League without image | Cold welding c38 power supply board | Sajage | |
| H BUSTER | HBTV-32D05HD | Don't care! blue led only | Replace the swollen capacitors on the power supply, it still won't turn on, replace the two diode 4007 d26 and d27 on the main board | Rodrigo cofferi | |
| HBUSTER | HBTV-32D05HD | Turned on for a few minutes - it showed a blue screen and then started working again | Transistor q6 smd w1a on the main board next to the side usb | Placed an npn bc 639 transistor | Paulo Braz - Braz Reparos |
| BUSTER | HBTV-32D05HD | Does not turn on blue LED flashing 5 volts ok | Transistor q2 | Changing transistor q2 can put mmbt 3904 | Ariel Santos |
| BUSTER | HBTV-32D05HD | Stuck on blue LED | Transistor q1 with leakage between collector base on the signal board | Ariel Santos | |
| BUSTER | HBTV-32D05HD | Plug it into the socket and the backlight is on, the TV works normally but the backlight is always on | Transistor on open signal board q5 | Ariel Santos | |
| BUSTER | HBTV-32D05HD | Cold, turns on normally, works for 10 minutes and turns off, the LED turns blue STB | Change q6 signal board | alcindo | |
| BUSTER | HBTV-32D05HD | Does not turn on, blue LED flashes, power supply pulsates | IC power supply driver with problems, rectifier diode measuring good, but in the circuit it doesn't work, replace. | Davi.sls | |
| H-BUSTER | HBTV-32D05HD | Locked on the blue LED. | Damaged reset q6. | Substitute 2n3904, yash. | adelimar |
| H BUSTER | HBTV-32D05HD | Locked on the blue LED, with all the right voltages | 16-pin u3 eproom replacement | Rodrigo cofferi | |
| BUSTER | HBTV-32D05HD | Sound appears and disappears | Short an smd transistor close to d05 close to the audio output capacitors | ||
| H-BUSTER | HBTV-32D05HD | When it turns on, no sound comes out, little by little tsound is a hoarse sound, then it becomes normal | Noise at the base of q17, causing q17 to conduct | Put a 10nf capacitor at the base of q17 | ELETRONICA AV TEC |
| H BUSTER | HBTV-32D05HD | TV does not tune HD channels and the input function does not work either | Factory data unconfigured | Remote control: menu + 8893 go to clear eeprom and press ok and after reset and press ok. Turn off for a few seconds and turn on the TV. | leitemarcellus |
| H-BUSTER | HBTV-32D05HD | The stand by LED is flashing, the power supply has no power at 5 volts | C22f on the power supply board, close to the cable connector that goes to the main board | Replace capacitor | Eletronicaaeb |