STILE D3201 TV Repair: Common Faults and Solutions.

Search: STILE D3201
Results: 16

STILE D3201 Repair Guide: Common Issues and Fixes

Brand	Model	Fault	Detailed Problem	Solution	By
CCE	STILE D3201	Don't turn on, with the orange LED flashing	PFC CI in the short	replace the U1 with the number 1607b which is under the power supply plate, near the large capacitor	Wsmartcell
CCE	STILE D3201	It turns on, lights Stanby, when tightening Power replaces green and nothing happens, then blinks error 7 in the power supply LED.	High tension T1 at the power supply, after suffering to the damn, as it takes the stroke to test another I already visualized the charred winding at one point of the traf.	replace T1 (MIP320g-a-T1/TLT-2796) of the MIP320G-HV0 power supply. Explaining line of reasoning: the 5 volts and power on font appeared and also the 12 volt and 24 power supply appeared, but only the 5 volts and power on, so I suspected the stuff after putting one point of the multimeter at the exit of the trafa and I could see a small high voltage spark and that's wsound I suspected the tread, but the TV was not lumped, so I discarded, so In the end everything worked out.	MIGUELTV
CCE	STILE D3201	Backlight access, without picture	Tsound was no 12V and 24V. Causes cold welds on the power supply plate		Eletrônica Cecé, Brumadinho MG
CCE	STILE D3201	turns on, then turns off, green LED flashing	5 leaky tec toc key, replace them all		guinga sdia goias
CCE	STILE D3201	Lamps come on and then go off and the LED on the power supply blinks	Always test whether the pins of capacitors c33 and c29 are leaking, as this will cause the lamps to go out.		ALBERI F S
CCE	STILE D3201	Lamps come on and then go off and the LED on the power supply blinks	Leak in transistor d20 connected to the cap. c33, remove and clean the area and resolder it, in my case it did the trick.		ALBERI F S
CCE	STILE D3201	Turns on and off with sound and image. d21 led flashing	Resolder the terminals of the con1 board next to the d21 led		Medeiros Eletrônica - MG
CCE	STILE D3201	Backlight keeps turning on and off.	The voltage on top of the pcf capacitor was 290v and should have been approx. 380v.	It was moisture residue under the power supply board. All you had to do was clean it with isopropyl alcohol.	Persio (TVCompany)
CCE	STILE D3201	Don't care! it only stays on the red LED	Ci u5 1,8v smd na principal		Eletrônica Cecé. Brumadinho MG
CCE	CCE STILE D3201	TV when turned on locks sound channels failing +b U5/U3 ok direct swap EC1/8/4 EC2/11/12	Replace cap ec1/8/4 2/11/12		Paulo Souza
CCE	STILE D3201 MP320G	LED turns green but does not turn on lamps (backlight) tsound was no voltage of 12 and 24 volts	Diode d7 open: just change it and give the budget. It generates a voltage of 12 volts to power u5	Replace diode d7 in4007 with a more powerful one.	ELETRONICA SALES.NATAL RN
CCE	STILE D3201	The red LED doesn't turn on, press power and it doesn't turn on. 5volts present at the power supply, 12volts absent, pfc does not activate	Change circuit transistors invert q20 to q23 r90a r87. replace q6 in primariod3 r97a and r11 both 10homs, ci pfc defective ci l6562 compatible
CCE	STILE D3201	Sound like robot disappearing the sound	Replace capacitor next regulator 1.8v ec4	Replace capacitor ec4 next regulator	Adao da central audio e video
CCE	STILE D3201	Orange standby ci invert oscillator warming up but tv won't turn on	Electrolytic ec10 = 220x35 power supply board, electrolytic = 470x16 close l1 regulator u2 main	Replace without testing!!! and good luck!	Jhone eletronica
CCE	STILE D3201	TV, turns on, but stops functioning or gives a stuck green screen, that is, processing freezes.	1.8v smd regulator position u5 on the main board.	In my case I replaced u5 (1.8v) and u3 (3.3v)	MIGUELTV
CCE	STILE D3201	TV with sound, screen lights up with no image	Open input fuse on the display strip and shorted ceramic capacitor.	Replace fuse fp1 and capacitor cp46	TIAGO