sony AE2B Repair Tips
Search: AE2B sony
Results 16
Results 16
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Sony | AE2B KVX2572U | No start up - LED flashes 7 times | dry joints IC602 & Q603 (front of panel near centre) | ||
| Sony | AE2B KVX2572U | Int cuts out with 13 flashes from led | dry joint C628 47ยต 50v pin 12 power trfmr | ||
| Sony | AE2B KVG2915U | No picture (A flashes once B flashes 13) - Field | IC501 STV9739, C1505 220uF 63V | ||
| Sony | AE2B KVG2515U | Dead with 350v on reg | R612 470k o/c | ||
| Sony | AE2B KVE2953C | Flashes 3 times | Tuner PLL fault - dry joint just above the innermost chip in the tuner module | ||
| Sony | AE2B KVA2942U | Int won't come out of st/by | Plug in board K1 was the cause - reqd 2 x TDA2052 Ics | ||
| Sony | AE2B KVA2942U | Int sound | Check R627 22R fusible on K1 panel for high res | ||
| Sony | AE2B | VOL WONT ALTER | REPLACE IC072 EAROM | ||
| Sony | AE2B | SATELLITE SECTION DEAD | CHECK PS605 ON PCB "D" N15 ( 600ma ) COECT TYPE | ||
| Sony | AE2B | Random OSD characxters appear | IC2002 u/s ( SDA5237P ) | ||
| Sony | AE2B | Pic blanks out - int & reverts to st/by | Dry joints Field o/p chip | ||
| Sony | AE2B | OSD APPEARS AT RANDOM | IC002 IC2002 SDA5273P | ||
| Sony | AE2B | NO SATELITE | CHECK CP605 CIRCUIT PROTECTOR | ||
| Sony | AE2B | Int audio | R627 27R hi res | ||
| Sony | AE2B | HISSING ON RH. CHANNEL | DELETE SPATIAL SOUND ( ONLY USED ON MONO TRANSMISSION ) | ||
| Sony | AE2B | Corrupted EEPROM and no teletext - set up in service menu | Press and hold any two buttons at the front of the set and switch it on from the mains. The letters TT appear on the screen to indicate it is in service mode. 2. To re-enable teletext: Type in 18 on the handset. Switch the set off then on again and teletext will be back. 3. To change other settings: Enter service mode as described above. Press menu and scroll down to 'Demonstration' An extra menu option for set ups will now appear. Scroll through the various set-ups and change as required. The TV system should be set to 'I' (for the UK) Enable the AV1, AV2 and front AV inputs as required. Enable the PIP (Picture in Picture) (if you want it!). Settings only take effect when the set is switched off then on again to exit service mode. Depending on the changes you may have to enter all your stations again using the preset mode. |