sharp DV5107H Repair Tips
Search: DV5107H sharp
Results 8
Results 8
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Sharp | DV5107H DV5132 D | NO SYNC OR NO COL , NVM DATA COUPT | ADD 8.2v ZENER BETWEEN PINS 5 AND 8 OF IC1003 CATHODE - PIN 8 Sharp RH-EX0413BMZZ | ||
| Sharp | DV5107H Deco 4 | Dead with 2A mains fuse blown | S/C across chopper Tr was chopper trfmr s/c pins 2, & 6 but when replaced, fuse blew again due to chopper Tr MJF18006 going s/c - also worth replacing TEA1039 chopper chip IC700 | ||
| Sharp | DV5107H | Reverts to st/by int | C721/ C719 10µ 50v; C722 100µ 16v; C723 4µ7 50v cured it | ||
| Sharp | DV5107H | R612 FAILS FOR NO REASON | CHANGE R633 TO 2.2ohm Sharp -XZ0204BMZZ ( R633 SAME AS R612 ) | ||
| Sharp | DV5107H | No start up - LEDs flashing red/green | HT high at 156v - LOPTfrmr & check 0R33 in psu & caps | ||
| Sharp | DV5107H | Dead - LED flashes red/green | LOPTx | ||
| Sharp | DV5107H | Dead - keeps blowing LOP trs | Line drive int - replaced tbase/RGB daughter board - used board from DV5105 - physically larger but electrically works ok | ||
| Sharp | DV5107H | Dead | Q702 MJF18006 s/c; 2A fuse o/c; CNX82A replaced as precaution |