sharp DV5132 Repair Tips
Search: DV5132 sharp
Results 12
Results 12
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Sharp | DV5132H Deco 5 | Trips at sw on | R612 3R3 safety res o/c | ||
Sharp | DV5132H Deco 5 | Lack of height | IC1400 RH-IX1426BMNO on digital pcb | ||
Sharp | DV5132H Deco 5 | Dead - R705 3k3 fusible o/c | Check 725 39R for hi res | ||
Sharp | DV5132H Deco 5 | Bright raster then shuts down at sw on | No 200v to crt pcb - C857 100pF leaky & R632 o/c | ||
Sharp | DV5132H | IN PROTECTION MODE THEN SBY | CHECK R612 FUSIBLE SUPPLY TO FIELD IC | ||
Sharp | DV5132H | Dead with led flashing red/green | R751 0R33 safety res had doubled res value | ||
Sharp | DV5132H | Dead with LED flashing between red & green | A common problem is due to R751 & R777 (both 0.33R) increasing in value by only a small amount. Best to substitute them rather than relying on meter checks. Sharp also advise replacing D751,D700,C756 and/or R612 at the same time. | ||
Sharp | DV5132H | Dead - blows chopper tr at sw on | Chopper tfmr s/c turns pins 2 & 7 | ||
Sharp | DV51322H | Int pic | R751 & 777 0R33 1w & C756 2200ยต 25v | ||
Sharp | DV5132 | St/by only unless you persevere with sw on | Field collapse briefly appears - No 28v to FOP chip TDA8175 as R612 2R2 1/2w o/c | ||
Sharp | DV5132 | No power , the HT was corning up but the set was t | R612 was opencircuit. A replacement restored norrnal operation. | ||
Sharp | DV5107H DV5132 D | NO SYNC OR NO COL , NVM DATA COUPT | ADD 8.2v ZENER BETWEEN PINS 5 AND 8 OF IC1003 CATHODE - PIN 8 Sharp RH-EX0413BMZZ |