sharp DV5932 Repair Tips
Search: DV5932 sharp
Results 12
Results 12
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Sharp | DV5932H DV5935 | Stuck in standby. | CRACKED PRINT AROUND LOPT T600 | ||
Sharp | DV5932H BCTV-A | E-W dist | L604 E/W coil burnt & C607 0ยต56 250v | ||
Sharp | DV5932H | Dead - line stage burn up | Replace C619 56nfd 250v cap R632 39ohm safety resister (o/c ) Line output transister 2SD1546 (leaky). | ||
Sharp | DV5932 DV5935 | NO SOUND , PIC. GEOM. WRONG. | RESET NVM SETTINGS | ||
Sharp | DV5932 | Procedure for setting NVM for no sound | Put set into service mode by momentarily shorting pins 2&6 on service plug as per manual. Scroll down to NVM pos with ch +/- adjust first to digits to correspond with location value on technical bulletin if the value number doesn't correspond go to NVM val and set last two digits to correspond with vol up & down; then store with standby button. Repeat this with all 19 settings then short pins 2 & 6 to come out of service mode. Switch set off and on from mains switch to reset. | ||
Sharp | DV5932 | FAILURE OF C619 | MOVE R632 FROM THE CLOSE AREA OF C619 AND REPLACE CAPACITOR | ||
Sharp | DV5932 | Dead | D709 s/c Replace with ( BYW56 ) r706 o/c fusible | ||
Sharp | BCTVA DV5932H | pic moved to top, E-W distortion | L604 shorted turns (RCILP0104CEZZ) | ||
Sharp | BCTVA DV5932H | Ok from cold, then pic starts to flash | IC500 TDA830Q | ||
Sharp | BCTVA DV5932H | E-W error | replace frame IC and 36V zener (s/c) | ||
Sharp | BCTVA DV5932H | dead or tripping | TDA8350Q s/c, C627 1nF 2kV leaky | ||
Sharp | BCTVA DV5932H | at switch on reverts back to stby | C725 220uF10V, C729 470uF 16V |