sanyo ED0 Repair Tips
Search: ED0 sanyo
Results 16
Results 16
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Sanyo | ED0 chassis | No sound | IC1680 TDA7253 & ICP853 o/c | ||
Sanyo | ED0 chassis | Bright raster - sound ok | R534 22R safety res & check IC500 TEA5101A RGB o/p chip | ||
Sanyo | ED0 CBP2876A | Dead - LOPTr Q650 2SD1556 s/c | C605 2µ2 line dr coupler leaky was cause | ||
Sanyo | ED0 CBP2576/2876 | no pic, no sound when entering tuning mode (just snow) | enter service mode and enter correct configuration code 02014 | ||
Sanyo | ED0 / EB1 | To enter service mode | Press & release diamond memory key on front ("Factory" shows on screen), press Index/Menu on hset within 5 secs; 1st tab on serv menu highlighted to allow entry of config code (02014) from handset. Pressing the R/C menu key again changes OSD to next setting, then alter with "Vol+" & "Vol-". To alter next parameter press sound button (under Vol+ button) to highlight next tab. Recommended values:- HO=02140; SO=01012; S1=00081; AO=00186; YO=00050; PO=15861; ZO=01369; P1=01665; Z1=00087; SP=00009 | ||
Sanyo | ED0 | To enter service mode | Press/release "Mem" on front panel & "Menu" on R/C within 5 secs | ||
Sanyo | ED0 | service mode | to enter service mode press MEMORY on TV and withing 5 sec press MENU on remote control | ||
Sanyo | ED0 | No pic due to field collapse | TDA8170 field chip blasted, R715 N25 cp o/c due to C703 100µ 50v | ||
Sanyo | CBP2876-00 ED028 | Txt moves sideways - pic ok | IC400 DPU2553 & check for line pulses to the chip | ||
Sanyo | CBP2876 ED0 series | Field collapse with thin bowed line across screen | Bad joints CRT coil connector | ||
Sanyo | CBP2576A ED0 chassis | No raster | TEA5101A RGB chip | ||
Sanyo | CBP2576A ED0 chassis | Height twitches, int bright raster with fb lines | Resolder conns on digital panel | ||
Sanyo | CBP2576 ED0 | No sound | Carry out "start NVM" proc as described in manual | ||
Sanyo | CBP2576 ED0 | No E-W correction | ICP R756 (N20) o/c | ||
Sanyo | CBP2576 ED0 | Dead - whistle only - LOPTr 2SD1556 leaky | ,Overheats when replaced with int narrow pic, replaced C750 47µ 50v & C705 2µ2 50v for hi esr & check for dry joints in LOP section | ||
Sanyo | CBP2576 ED0 | Burning smell then dead | Burn up on pcb at line scan connector K-FF |