samsung P58SC Repair Tips
Search: P58SC samsung
Results 13
Results 13
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
Samsung | CB5020 P58SC | Tuning not stopping | Replace R116 120Kohms this was open circuit | ||
Samsung | CB5012Z P58SC | No colour, stuck on secam only | Check R514 100K open circuit or very high value | ||
Samsung | CB5012Z P58SC | Stuck in SECAM mode | Change resistor R514 100K | ||
Samsung | P58SC | LOW WIDTH + BURNING SMELL | L824 OC OR DRY JOINTED | ||
Samsung | P58SC | LOW WIDTH + BURNING SMELL | L824 OC OR DRY JOINTED | ||
Samsung | P58SC | crackle on sound | crackle present at pin 12 TDA8305. C603 & 605 22nf | ||
Samsung | P58SC | crackle on sound | crackle present at pin 12 TDA8305. C603 & 605 22nf | ||
Samsung | CI5013T P58SC | WONT START OR TRIPS , WITH NO SBY LIGHT | CHECKR 811 100k | ||
Samsung | CI5013T P58SC | STUCK IN STBY NO 12v OR 16.5v | MICRO 10Mhz XTAL US | ||
Samsung | CI5013T P58SC | Int no startup - Stuck in standby. | 100uf 25v & 100uf 16v next to TDA4601 PSU IC heat sink. | ||
Samsung | CI5012Z P58SC | Sound absent | All volts around IC602 audio chip correct & replacement chip failed to cure - R617 220k (pins 3 & 4) o/c | ||
Samsung | CI5012Z P58SC | Bright white raster with fback lines | Dry joints on crt base though not obvious | ||
Samsung | CI3312Z P58SC | Dead with mains fuse or R601 5R6 7.5w o/c | Check C816 for s/c or leaky (2n2 2kv) |