Search: GRADIENTE
Results: 1317

GRADIENTE Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
GRADIENTETV-2924 CIN
SAM
Beeping at the power supply as if it were a shorted flybackC509 330mf 400v exhaustedReplace c509carlosss
GRADIENTETV-2924 CIN
CIN SAM
Whistling at the power supply as if it were flybackC509 330mf 400v exhaustedReplace the samecarlosss
GRADIENTETV2920
Vertical closedPoor contact on the vertical CI pinsResolve everything ready!orlando lott
GRADIENTETF2952
Bowl effect on the screen, or pincuchion defectEw q403 circuit with pci failureBRUSKE
GRADIENTETV 2922
I'm soundIf you have already reviewed everything ex. memo, you from the sound ci etc.. see c-602 smd next to the cracked sound ci.Master Eletronica
GRADIENTEGT - 2011
Image completely embedded, without definitions.Solution: change kinescope socket (tube)BARRETO CRUZ
GRADIENTE1421
PCI650
League 2 seconds log offMicronas with cold solder and it doesn't turn on even after resolderingReplace the r 55 180k and c 405 22k and release the fley back pin and turn it on, it appears vertically closed, connect the pin again and everything works fineluiztvsom
GRADIENTETV-2020
Without secondary power supplysC808 8k2 shortedReplace for another one with high insulationjasvan souza
GRADIENTETF2953
Closed horizontalC429 364j 630vReplaceEletroClaudio Aguas Belas
GRADIENTED-860
It doesn't turn on the power supply ci when replacing it, it shorts out It's the power supply capacitor 22ufx400v which is very defective and runs out @@@Ci top253, cap 22ufx400vEETRONICA ARNI-L. LEAL- SC
GRADIENTED-860
It doesn't turn on the power supply ci when replacing it, it shorts out. It's the 22ufx400v power supply capacitor, which is very defective and runs out.Ci top253, cap 22ufx400vEETRONICA ARNI-L. LEAL- SC
GRADIENTEGBT2911
No stand by, normal voltages. does not turn onChange the 20,250 crystal20.250Eletrônica Nel
GRADIENTEM-34I
Turning off by itselfAfter brainstorming a lot with this TV, the Q542 was the cause of this defectAll I had to do was remove the q542 from the board and the problem was solved and it was only possible with the advice of another technician who posted this tipPATRICK
GRADIENTEGT2022
Defect does not turn on without +b and protectingCause: capacitor 823 of 471 x2kv shortedklein
GRADIENTEHT-M 299S
Vertical with a line in the middle of the screen, but with a shrunken image at the bottom and topCheck 26v voltage, if it is low, change rf-542, it has changed! ....joelton / infoaçu eletronica
GRADIENTEHT-M299S
Vertical top of shrunken screenCheck 9v ci 541 power supplyIf it is low, replace the replaced fr-543 resistor.....joelton
GRADIENTETF 2140
When I turned on the TV it just kept blinking and didn't work.I replaced the c918 and solved the problem with the TF2140 gradient TV, thanks for the tipsThis email address is being protected from spambots. You need JavaScript enabled to view it.
GRADIENTETV2021
SAMS
When turned on, it looks like a white screen with scan lines and then turns off.Replace 180k r-55 on the 180v line.João SF.
GRADIENTEHRM290S
TV with audio but no syncDefect ic,701 {tda 8361} and just change the TV oksliva
GRADIENTE2922
It turns off by itself as if it were using the remote control.Protection circuit acting, d404 (in 4148) shorted, also check zener zd412-22voltsSwapped d404 - in4148Osmar Antonio