GRADIENTE TV Repair: Common Faults and Solutions.
Search: GRADIENTE
Results: 1317
Results: 1317
GRADIENTE Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| GRADIENTE | GBT2011 | Does not turn on power supply much lower than normal 113v was at 45v. voltage pulsing a lot on pin 8 of ic 501 | Ic 805 tl431 tsound is no point in measuring just by changing | Ready, old TV, brand new! | RTZCOMPUTER |
| GRADIENTE | GBT-2010 | Doesn't start | When activating the key, tsound was 112v from the power supply and voltages on the regulators ic855 and 853, the LED did not light up and tsound was no voltage at the output of the ic 851. When removing solder from this c.i. on the output pin, the 5v came back, I followed the trail and removed the cap. 855 (470/16v) and when turning on the LED it came on. After changing it, it remained on standby and when activating the TV channel it turned on and worked normally | josé Gusmão | |
| GRADIENTE | HT-M299SC | Closed vertical (wavy line) | Cold solder not bdv connector. | PY3IG | |
| GRADIENTE | GBT2911 | Nothing works | 100n short capacitor c13 located on pin 46 of the micro controller | Appears to be the micronas shorted | MACCELETRONICA |
| GRADIENTE | TF-2953 | LED keeps flashing without power supply voltage | Note: fb801 jumper with oxidation | Alvaro (prolar) | |
| GRADIENTE | 2022 | Doesn't start tic tac | Capacitor short me | Replace cap.823 470k | fernando timbauba PE |
| GRADIENTE | TV-2922 | TV turning off by itself | Def c805 10uf160v colocar cap. de 22uf250v ok | Help yourself leave your tip | ELETRONICA ARNI>L. LEAL-SC |
| GRADIENTE | TV-2922 | TV turning off by itself | Def c805 10; | Help yourself leave your tip | ELETRONICA ARNI>L. LEAL-SC |
| GRADIENTE | TV 2021 | No color | Ic 5 eeprom can be 24c16 just change and go for the hug | CARLOS AUGUSTO ELETROSILVA CANAVIEIRAS BAHIA | |
| GRADIENTE | DVD D 461 | Doesn't start | C 908 47 x 25 c 910 1 x 50 | CARLOS AUGUSTO ELETROSILVA CANAVIEIRAS BAHIA | |
| GRADIENTE | GBT2011 | Volume bar stuck on the screen at maximum but without sound, and sby led oscillating. | Defective microns | Replace it | |
| GRADIENTE | HT-M277S | Turns on tsound is sound when the image appears with the vertical 2 cm missing from closing, it turns off and the LED blinks. | Electrol capacitor. c413 2200uf 25v dry | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| GRADIENTE | D461 | Doesn't start | Change the power supply electrolytics | FLAVIO | |
| GRADIENTE | TV GBT 2910 | Warps the whole image like AGC on old TVs | Ceramic filter (that fi filter with 5 legs) | After the replace, the image came back perfect, | JOBOVI |
| GRADIENTE | HPS2981C | Lock keys | Replacing resistors r 756 4k7 r 749 12k r 206 22k | Aldo Araujo Silva | |
| GRADIENTE | TF 2140 | When activating power, the LED turns off but does not work | R701 open | Check if when power is activated the base of q702 goes to high level if so then r701 is open | gilsce |
| GRADIENTE | NEXT 29L | Reduced image on the sides | I tried to adjust it in service mode but the adjustment did not work. | 27k r316 on ew circuit, open. | luis carlos |
| GRADIENTE | TF2953 | When plugging in the TV, the TV keeps turning on and off and if you increase the screen, the image has return lines and the width changes. | The on/off micro switch was removed and when plugged in, the TV no longer turned on. | Changing the on/off micro switch that was activated directly. | Helio Fernando (Caruaru) |
| GRADIENTE | TF-2140 | Sometimes it doesn't turn on and the LED blinks | Check welds on the r936 line | Resolder... | |
| GRADIENTE | TV 2020 | Vertical closed top | R 320 open | AMSMARIANO |