GRADIENTE TV Repair: Common Faults and Solutions.
Search: GRADIENTE
Results: 1317
Results: 1317
GRADIENTE Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| GRADIENTE | HT-M 299S | Vertical with a line in the middle of the screen, but with a shrunken image at the bottom and top | Check 26v voltage, if it is low, change rf-542, it has changed! .... | joelton / infoaçu eletronica | |
| GRADIENTE | HT-M299S | Vertical top of shrunken screen | Check 9v ci 541 power supply | If it is low, replace the replaced fr-543 resistor..... | joelton |
| GRADIENTE | TF 2140 | When I turned on the TV it just kept blinking and didn't work. | I replaced the c918 and solved the problem with the TF2140 gradient TV, thanks for the tips | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| GRADIENTE | TV2021 SAMS | When turned on, it looks like a white screen with scan lines and then turns off. | Replace 180k r-55 on the 180v line. | João SF. | |
| GRADIENTE | HRM290S | TV with audio but no sync | Defect ic,701 {tda 8361} and just change the TV ok | sliva | |
| GRADIENTE | 2922 | It turns off by itself as if it were using the remote control. | Protection circuit acting, d404 (in 4148) shorted, also check zener zd412-22volts | Swapped d404 - in4148 | Osmar Antonio |
| GRADIENTE | GT 2022 | TV without video screen off, sometimes bright streaks appear. | Ic201=ta8822sn shorted. | It was replaced and resolved. | Armando eletronica EvoluSom |
| GRADIENTE | HRM 290S | TV does not turn on or is not working | Str s6709 ou 6707 | Replace of the same | eletronica santo antonio em boa vista mg |
| GRADIENTE | TF2951 | Don't care! | R820 | Andrade | |
| GRADIENTE | TS 2960 | No sound (mute activated) defective micro | Remove r 733 and uallaaaa | DEBIQUE | |
| GRADIENTE | TV2922 TV2922 | Turning off after a few seconds | C805,-- problem heats up a lot | C805.....resolved.....good luck | NEUPSX4DOWNLOAD |
| GRADIENTE | D-203 | CD drawer won't close | Cracked optical drive carriage motor gear | If you can't find a new replacement gear, grind the motor shaft with sandpaper, making it thinner and fit the gear again by gluing it with bonder. | Rubens |
| GRADIENTE | GT - 1422 | TV does not turn on and the stand by LED does not light up | Solution: exchange - zd 802 and str s 6707 | BARRETO CRUZ | |
| GRADIENTE | TF 2953 | No horizontal width | Q405 smd aberto | Replaced, just joy | ALEMÃO |
| GRADIENTE | 2021 | Image all red right down to the characters | Co16 memory | Replace the same and go out for the hug | eletronica dimencional |
| GRADIENTE | TF 2952 | This TV arrived with a strong tick, tick, tick as if the horizontal output transistor or some capacitor in this line was shorted. However, it was nothing like that. the problem was the shorted 406 diode. | After replacing the diode, the device showed excessive width. The short in diode 406 also caused a short in the smd transistor q405 bc 858. After replacing the transistor q405, the width remained normal. | JFR | |
| GRADIENTE | GT - 2022 | Does not turn on, stand by LED flashes quickly for a period between 01 and 05 minutes then stops and does not turn on | Solution: change str s 6707 (ic 801) | BARRETO CRUZ | |
| GRADIENTE | GT - 2022 | TV does not turn on and the stand by LED does not light up | Solution: replace zener diode (zd 802) 18v. and str s 6707 | BARRETO CRUZ | |
| GRADIENTE | GT - 2022 | TV does not turn on and the stand by LED does not light up | Solution: replace zener diode (zd 802) 18v. and str s 6707 | BARRETO CRUZ | |
| GRADIENTE | GT - 2022 | TV does not turn on and the stand by LED does not light up | Solution: replace zener diode (zd 802) 18v. and str s 6707 | BARRETO CRUZ |