GRUNDIG TV Repair: Common Faults and Solutions.
Search: GRUNDIG
Results: 948
Results: 948
GRUNDIG Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| GRUNDIG | T55-2401 TEXT E1 | No voltage from g2 | Replaces the transfer lines per hour 80062 and already has g2 voltage but with defective colors | Americo pereira | |
| GRUNDIG | GDP-1400 | Doesn't turn on anything, no voltage on the secondary | C111, 2200mf/10v. u901, ice2a0565 | Replace capacitor on secondary and ci on primary | S.O.S. Electrónica - Fundão |
| GRUNDIG | CUC5303 | Swapping tda8214 for tda8215 (no sound) | Change r522 from 47k to 39k and remove r529 | António Correia | |
| GRUNDIG | T51-060 CUC6300 | Horizontal very open, r572 open | Replace r572, c573 and c574 | Replace r572, c573 and c574 | gloop |
| GRUNDIG | ST55-908/8 DOLBY CUC2121 | Turns on does not start (stby) | Ic vertical (tda8174) | Ver c53054 (1μF/100v), br81053 (2,2r) | JOAQUIM CUNHA |
| GRUNDIG | MW70-2699NIC/T0P CUC2059 | Does not turn on; led off | Fusivel si62501 (2ap/250v) ; ptc (t209) | joaquim cunha | |
| GRUNDIG | P37-060 CUC6300 | Vertical closed | Open r591 and tda8174w with pin 1 in dc | Subst r591 por 0 .68r tda8174w | camane |
| GRUNDIG | T-55 830 TEXT CUC 7303 | White line in the middle of the screen | Vertical deflection failure | Tda 7303 replacement | Ruca23 |
| GRUNDIG | 8214 | Color bars on the screen approximately 5cm wide | Cond. electrolytics 4.7uf/63v without capacity (one in each video output) | SIMP | |
| GRUNDIG | CUC 2103 CUC 2103 | It tries to start and then goes to standby, increasing the screen and tsound is a horizontal stripe when it tries to start! | Ic 50010 (vertical IC tda1771) shorted, r54006 open | Replace ic50010, r54006, c52002, c63054 (electrolytic next to ic do vertical) | CarlosVale |
| GRUNDIG | CUC6300 CUC6300 | Intermittent image loss, loss of image and loss of sensitivity (white screen) | T936/bc548 flashing | Replace t396/bc548 | SIMP |
| GRUNDIG | M55-5501 K2 | Image two seconds later goes into standby sometimes lasts two or three hours | C651 low capacity d611 leaking | obombeiro | |
| GRUNDIG | XENTIA 42LXW | Does not tune through bdo tuner | Replace tuner or 4mhz crystal inside it | jose almeida tavares | |
| GRUNDIG | ST-72-760/8TOP CUC5365 | Alloy does not start, r576 with high temperature | Transformer mat29201.029.10 (hr6514) | JOAQIM CUNHA | |
| GRUNDIG | T55-549 CUC5302 | Does not go out of standby, it immediately goes into protection | (t583)bc548 with leak | TELEGAIA | |
| GRUNDIG | CUC3400 | Return lines and excess shine | Verificar zener d707 (4,7v), c711, c731 | ||
| GRUNDIG | CUC3400 | Inop. 800ma fuse blows | Check c667(2u2), c653(4n7), d663, d664 | ||
| GRUNDIG | T55-743 EURO CUC6300 | Interference in the image | Check internal welds of tuner | ||
| GRUNDIG | G1000 G1000 | Tsound is no image dark screen with sidebar | Tr300 (bc847) leaking | ||
| GRUNDIG | CUC7303 | Flashing LED does not start | C667 |