Gradiente TV Repair: Common Faults and Solutions.
Search: Gradiente
Results: 1318
Results: 1318
Gradiente Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
GRADIENTE | GT-2011 | Power supply arming and disarming, after a few minutes you could see the warm fly-back. | Fly-back | Replace o fly-back | Edson S.A. |
GRADIENTE | TF2952 | Led does not light. does not have the + b 125v. | R-809 open. | pernambucano | |
GRADIENTE | TV2922 2924 2953 GBT2911 | Dark image you increase the screen of the retrace line | R831 | R831 | thiago |
GRADIENTE | GT2022 | The TV doesn't turn on and it keeps chirping like it's burnt out. | The TV was making noises as if the bu was bad, when it was measured in place, it was actually measuring directly, but when I took it out it was fine. then I measured it with the test on the board without the bu. I was going directly from the base to the collector of the q402, that's when I got to the 681k/2kv capacitor c402, which was shorted, so I added another one and it was fixed. obsv: 681k is the same as 681 picofaraides or almost one nanofaraides, you don't need to measure it directly, thanks guys from the forum | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
GRADIENTE | TV-2020 | TV does not oscillate, press the button to turn it on, the LED goes off and comes on again | R401 of 1k open c402 of 223k 200v shorted and d421 shorted | Replace the same ones for new ones | eletroclaudio aguas belas |
GRADIENTE | GT 2020 | Whitish image with black spot on the left | C-540 4,7/250v | Replace for 10/250 | ÁdrianChapadãodoCéu |
GRADIENTE | GTV142 | After a concert and changing the vertical output, the TV turned on, but then turned off, using a timer. | The shutdown occurs due to factory default protection when the CI understands that there is a tape in the video cassette compartment. | Solution I placed a tape manually, after dismantling it completely. Once this was done I turned it on again, with a video cassette tape inside. the timer recognized the setting, releasing the tape and disabling the system. That's it, another headache resolved. | demervalignacio |
GRADIENTE | TV 2020 | Vertical banging bottom | Replace c307 39n 100v | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
GRADIENTE | TV2020 | Vertical white stripes at the bottom of the screen | 07 | To remove | beto2828 |
GRADIENTE | TV2020 | Vertical closed | Flyback leaking vertical outlet burnt, r321 open | Replace | |
GRADIENTE | TV 2922 TV 2922 | Turns off after a few seconds, sometimes normal (image always normal) | Exchange ic901 (tda6107), it fails to generate (pin 5) the reference ik for the micro | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
GRADIENTE | GT1422 | It doesn't show an image even with a DVD, it gives normal sound, | Swap ic501 ta8808bn 64 pins | Delegado | |
GRADIENTE | TF-2150 | White screen with a dark band at the top and with lines like lines of retraces | Eeprom memory | Rewrite or replace for a new one | eletroclaudio aguas belas |
GRADIENTE | TV2922 | It turns on by itself and the volume is turned up to maximum at any time. | Some touch keys on the panel (channel + and volume) with homic value (dirt) | Replace all keys | MAIRES |
GRADIENTE | TV2020 | Power supply varies normal 114v voltage and drops | Checked all s.h components. tested fly to see if it had a short, it seemed to be good, but it was shorted, replaced it was fine. | Replace do fly ov2094/h | Bruske |
GRADIENTE | AS-M550 | Volume does not work, the values do not appear on the display | Change ci d780034 or complete side plate | The defect on this board was (discovered). | Eronaldo(arteron) |
GRADIENTE | HTM 277 | No sound | Off in the sound menu | You can only get it right with her original remote | HP ELETRONICA |
GRADIENTE | TS 2960 | It doesn't turn on, the power supply is loud | R 873 (360 0hms) | HP ELETRONICA | |
GRADIENTE | GT-2022 | Dark and blurred image | C540 on 180v line | Replace c540 4,7μF 250v | beto2828 |
GRADIENTE | GT-1422 | Excess vertical linearity | When turned on, the image appeared normal and immediately the vertical linearity expanded. defect caused by zd-301 (7v5) which in the multimeter test showed as normal and even polarized with voltage from a 12v power supply in series with a 1kΩ resistor it also seemed to be perfect. | littlecarlos |