JVC TV Repair: Common Faults and Solutions.
Search: JVC
Results: 432
Results: 432
JVC Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| JVC | C140EKY | Int start up | Sm cap top left of thick film unit faulty | ||
| JVC | C140EKY | Dead - st/by only | Ht at d921 but does not get past q923 (ht reg) no power control from micro, dry joints on xtal x001 on micro sub panel | ||
| JVC | C140EKY | Dead - st/by only | Dry joints emitter of q924 in psu | ||
| JVC | C140EK | No chan store - no clock pulses pin 10 ic001 | Come from pin 31 ic002 but lost along way - fitted wire link | ||
| JVC | C140EK | Int startup. | R905 180k gone high. | ||
| JVC | C140 | Set switches off , changes channel , adjusts volume. | Crystal on sub panel dry | ||
| JVC | BYX CHASSIS | No memorise chans or settings | Ic001 mn1226s, c106, c107 on station select module | ||
| JVC | BYX CHASSIS | Loss of some chans | If module sby-f004a proved to be heat sensitive - retune t102 v c osc coil | ||
| JVC | BYX | Int tuner drift & patterning | Dry joints if module | ||
| JVC | BX11 | Tuning drift from cold | 4 sm electrolytics on sub panel c015 22µ 6v, c016 0µ47 50v & c014 3µ3 50v | ||
| JVC | BX11 | Tuner drift | Replace sm caps c014, c017 3µ3 50v; c015 22µ 6.3v & c016 0µ47 50v in station selector module | ||
| JVC | BX11 | No chan store (search tune ok) | Check print, thro conns etc in stn sel module - replacement expensive | ||
| JVC | AVS25SD4EK | Comes on briefly to show good pic in ext3 then reverts to st/by | Possible eeprom corruption - press "i" and "audio mute" simultaneously on handset. this will put it into test mode. another quirk of some eeprom problems is that the set will often switch to standby when going into or out of service mode or when pressing "vsm reset". | ||
| JVC | AVK21T | Dead after lightning strike | Change strs-f6653 / opto couple / q941 / q942 / d945 6v2 /ic901s1854 error amp | ||
| JVC | AVA14M2 | Int cuts out | Check for cracked print around loptx | ||
| JVC | AV32WFP1EK | St/by only | C966 0.01µ s/c | ||
| JVC | AV32R25EK-S | Sound very dist on nicam - ok on mono | R chan o/p from msp chip (nicam processor) ic631(pin 31) 6v p-p & badly clipped - l chan ok - chip faulty | ||
| JVC | AV29TS2EK | Powers up with eht then shuts down with brief small raster visible | C521 fb tuning cap o/c | ||
| JVC | AV29TS2EK | Int sw off | D405 on lh side of fop chip o/c (in x ray prot) - can remove q573 x ray tr to prevent sw off whilst check for cause of fault | ||
| JVC | AV29TS2EK | Field - jumping like dry joint | 22k resistor on print side under glue had dry joint |