LG TV Repair: Common Faults and Solutions.
Search: LG
Results: 4834
Results: 4834
LG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
LG | 21FU6TL | Doesn't start | Capacitors in positions c25 and c 515 shorted | Exchanging them | Airton Filgueira |
LG | 50PH4700 | With sound and without image | Replace q401 and q402 both 30f133 also replace c417 and c418 both 2.2nf at least 1000v | giovano eletronica | |
LG | 55LY540S | LED bar, blinks and goes out | Replace all LED bars, bus 100% compatible 55lb/55lf line | 55lb5600, 55lb6200, 55lb6500, 55lf5600 | Maike SR |
LG | 21FU6TL | Turns on and off then arming protection, if you release the q16 the tv turns on normally, but with the vertical closed | R311=30k open | Replace it with another and run to another | Antonio Carlos (Eletrônica Renascer) |
LG | CM9730 | No audio | Turns on works normally cd, radio, bluetooth and usb. when you increase the volume no audio comes out on the 4 outputs, measure the voltage that feeds the pre-amplifier and mosfet -40v +40v it is giving 4.6v this is low, I removed the 18mn60n mosfet to see tsound is a leak they are all good, the defect was a short in some components: pc902-el817 is shorted, q956-ktc3203y is leaking, zd903-code smd y5w 16v shorted, on pin q956 to two resistors r973 and r998 - 22r open smd, on the same track as the bad c932-22uf 50v resistor, replace it, zd904- 16v smd code y5w with leakage, remove it from the board and test, ic902 - ice1h01-1 with leakage, I replaced these components and the horn appeared -40 +40 and audio normalized | Defect resolved | Andre |
LG | CM9730 | Standby LED doesn't turn on, press the power button and the remote control doesn't turn on | This defect is not a power supply, nor the main board, they are touch switches with a problem, I replaced them all, and not just the switches, near the bu2090f around the LED set, some are shorted on the other side, I also replaced all the LEDs with leaks and shorts, I turned on the sound worked | Defect resolved | Carlos |
LG | CM9730 | No audio on all 4 outputs | Measure the voltage on the power supply board +40v and -40v, it is giving 0v, I removed the mosfets, all 4 are leaking 18mn60n, I replaced them with the original, solved, audio normalized, 4 outputs worked | Defect resolved | Andre |
LG | CM9730 | Turns on in seconds turns off | Photocoupler el817 3 with leakage, 1 shorted and pc902 on the pin of this photocoupler to q956 - ktc3203y with leakage, on the pin of this transistor the zener diode shorted zd903 - code y5w, and a 16v smd diode, I changed the sound, it turned on, it didn't turn off but | Defect resolved | Andre |
LG | CM9730 | Doesn't start | Test the power supply it's ok, the cause was a faulty touch switch, I replaced all 3 boards and it wasn't just the touch switches either, near the bu2090f the LED was short, I tested it on both sides I replaced them all | Defect resolved | Andre |
LG | 21FU4RL | Plate or cushion defect | R 451 15k | AIRTON | |
LG | 42LP560M 60LN549E 55LN549E 55LN541C 47LN549E 47LN541C 42LN549E 42LN541C 39LN549E 32LP560M 32LN549E 32LN541C | The TV restarts repeatedly after it has been running for a while | Poor contact between the power supply and the mainboard. The drop of 3.5v_st is detected by the unstable contact of the connector. replace the psu cable (connector) and socket, (apply glue to the connector and socket. | Anderson | |
LG | 32LF57 49LF51 49LH57 49UF64 49UH60 | Blue screen with spots | This problem is caused by the elimination of the silicon deled pkg replacing the led strips | Anderson | |
LG PLASMA | 50PB560B | Turns on the sound and normal image after a few minutes the screen turns off leaving only the audio | Faulty controller board | After changing it, it returned to normal. | Eugenio |
LG | 29FU6TL | Image with cup effect | R318 was replaced, 3k9 resistor open. | José delta line | |
LG | 26LG30R | When turning on, audio gaps appear, you have to turn it off and on again. | 1.2 volt regulator heating up and creating resistance to the electrolytic capacitor on the back of the regulator, just change it and be happy. | Adriano oliveira | |
LG | 32LH570B | Doesn't start | Positive short circuit with negative, because capacitor c2305 is short circuited. on the main board. | Removal or replacement of capacitor c2305 | Carlos Alberto (ELETRONICA BATURITE) |
LG | CM4340 | No sound, s-protect appeared | Ic 931 12v regulator, giving 7v | 12v 78r12 regulator replacement - ic931 | VICTORINO |
LG | 42PJ350 | Relay does not turn on | Join junper 73 with 53 | Ílis | |
LG | 43LJ5550 | Standby light comes on when you press the power button on the control stanby LED flashes 4 times | The power outputs were checked and they were at 7 volts varying | The power supply board was replaced as it could not find a ci smd sc2016 position u601. | Adriano Miranda |
LG | 32CS460 | Tunes quickly and doesn't memorize anything | With correct nutrition on the varicap. | The varicap.(tunner).celetronic was replaced. | This email address is being protected from spambots. You need JavaScript enabled to view it. |