PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PVT2014 | Tsound is no + b the LED does not light up / pressing the power key several times until it turns on | C 504 47/25v | Replace capacitor | matieski |
PHILCO | PCS2076 | TV with stand by pulsing and not stabilizing and a very low power supply of around 180 volts wsound it would have to be around 130 at most | When checking this power supply, the +b of the flayback was giving about 180 volts, so I went to check the primary and secondary power supply to see wsound the defect was. | It was then that, next to the power supply transformer, tsound were two resistors auterated, their real values, r910, and r 912 of 0.47Ω, auterated to a value of 10Ω. The color of these resistors are yellow, violet, gold, gold, white. power supply file returned to normal | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILCO | PCS2976 | TV with stand by pulsing and not stabilizing and a very low power supply of around 180 volts wsound it would have to be around 130 at most | When checking this power supply, the +b of the flayback was giving about 180 volts, so I went to check the primary and secondary power supply to see wsound the defect was. | It was then that, next to the power supply transformer, tsound were two resistors auterated, their real values, r910, and r 912 of 0.47Ω, auterated to a value of 10Ω. The color of these resistors are yellow, violet, gold, gold, white. power supply file returned to normal | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILCO | TP-1452N | Screen blown. | R711 and c719 open | I replaced the fly-back without success. the problem persisted. So, analyzing the voltages I saw that the voltage died on r711 (it was open) and c719 also burned. I replaced the r711 with a 10r / 1w resistor (the correct one is 4.7r-1/2w but I didn't have a smaller one) and the c719. the d703 diode was fine, but nothing prevents it from being replaced as a precaution. | Lucelio |
PHILCO | PCM1446 CPH 04 | Image without contrast, as if it were tired. | R 716 of 100k open | And good luck | Jhone Eletronica |
PHILCO | TPF2121 | Turned off | Open fuse d901 and 903 short | Replace c909 short | Nilson |
PHILCO | PCM 1451 * | It didn't start normally, according to the customer's information, it started when it wanted. After checking, I found the t-702 had no continuity and replaced it and the TV was normal. | T 702 | Your replace | wagner |
PHILCO | PCM 2051 | LED keeps flashing but the TV doesn't start | ********** | Def. c 913 1mf 100v replace with another one even if it is good in the test | Francisco Ivan Basílio - Nova ELETRÔNICA - Ibiara - PB |
PHILCO | PCM 2051 | LED keeps flashing but doesn't start | Defect c 913 1mf 100v replace with another one even if it is good in the test | FRancico Ivan Basílio - Nova ELETRÔNICA - Ibiara - PB | |
PHILCO | PCM 1446 | White screen and blinking LED | Poor 180v supply (low) | Ver capac 10μF250v seco | MAIRES |
PHILCO | TPF 2940 | Cup effect | Dz 1702 replace, note also check connector 1702 the same with bad contact burns 100r resistor and zener | Roberto Consertos | |
PHILCO | PH-14C | Screen turns green and darkens | Damaged transistor on rgb board | V933 (BF 423) was replaced on the RGB board with leakage | George Pontes |
PHILCO | PCM2044 | Doesn't work, LED blinks | Checking the voltages in the primary power supply, all were normal, except for the 20v in c915, which was in the range of 12 to 13v. in the tsh collector also normal (93.6v). the voltage on pin 36 of ic501 was at 3.1v. defect c705 (100μfx25v) almost sold out. on the capacimeter it read 23μf. | littlecarlos | |
PHILCO | 1444/2044 CPH-05 | Normal image when turned on, then green screen and inverts the colors like NTSC. | Integrated circuit tda 8361 | Adhemar Caetano da Silva | |
PHILCO | TPF2130 | It doesn't turn on, it doesn't have 14 V | Resoldar r 936 | eletronica rodrigo | |
PHILCO | PH14E | Rainbow effect screen | Saida is vertical | Replace vertical output stv9302/la78040 | eletronicaapolo |
PHILCO | PCM2046 | When the screen increases or tsound is a lot of contrast, the screen flashes or expands quickly with a tendency to arm the protection or does not turn off but shakes the screen. | Changing capacitor c-716 for a small 1k (102) ceramic works in the abl area | Replace capacitor c-716 for a small 1k (102) ceramic | guaracy borges |
PHILCO | TVC 2039 | Normal sound. image with horizontal white stripes and pops. | Replacement of capacitor c724=470pf and r725= 4.7Ω fusistor, TV started working again image ok. | domingos aladir | |
TV PHILCO | PC-2027U | The alloy makes a horrible noise in the power supply transformer. | Check c911 may be dry without capacitance. | I replaced it and it was beautiful. | Eronaldo |
PHILCO | PC 1444 CPH-05 | Resistor r 713, 100k aberto | altair santos |