PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCS-2956N | Interference in the image, RF type | C208 | ||
PHILCO | TP 2052 | Does not tune channels - autoprogramming does not capture channels. | Transistor q201 bad. was open, cutting +b from seletronic | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | PCS-2700N | Image disappears after a while | Check cable welds to kinescope board, r708, solder on kinescope board | ||
PHILCO | PCS2976S | Dead | Ss09 | ||
PHILCO | TPF-2940 | No audio in rf | C401 e c402 | ||
PHILCO | TPF-2130 | Does not turn on, relay keeps tripping | Solda em r931 18r 2w | Edgar | |
PHILCO | PT2053 | It doesn't turn on, but the LED keeps flashing. | DS08. | Cold solder on the anode. | Paulo Augusto da Rocha Júnior |
PHILCO | PCS-2976S | Vertical varies at the bottom by a few centimeters | Possible cause r910 and r912 | ||
PHILCO | PCM-1446 | Wavy image | C-905 220mf x 400v | ||
PHILCO | TPF 2130 | It doesn't work, the 9v power supply is missing | Absence of 9 volt power supply (bad contact on r 931) | Resoldei o resistor r 931 ( 18rx2w) | Leônidas (Léo) |
PHILCO | PCS-2956 CP01LR01 | East west defect | Reduced condition with cushion effect symptom | Solda fria r 722 10Ω | Airon |
PHILCO | PC-20R42 | With image turns off | R723=27k e c310. | Andrade Sequeira | |
PHILCO | PCM-1446 | Doesn't tune in | Reset: with the TV off press: channel+ and channel- simultaneously turn on the TV, when the LED goes out it starts working | ||
PHILCO | 29S4F | Does not work on remote control | I already got this defect, I just had to reset it by doing the following procedures: if the ic101 version is tda9370 n2 and tda9373 n2, proceed like this: unplug the socket, simultaneously press the "menu and volume-" keys on the front panel, turn on the plug plug into the socket and wait 10 seconds, after this period, just release the "menu" key and keep the "volume-" key pressed for another 2 seconds, turn on the device using the "power" key. | See forum philco problems with remote control | otaviano |
PHILCO | TPF 29S4F | Generates and cuts in 3 seconds | C-1703 value 5k6 open | ramiro lima | |
PHILCO | TPF 2940 | Dull, abl | D-602 I like: in4148 | ramiro lima | |
PHILCO | PCM-2051 | Blinking led | C704 | Andrade Sequeira | |
PHILCO | TP2052 | Fountain pulsing | 1x100 capacitor in primary | alessandro | |
PHILCO | PCM2046 | Does not tune channels | C208 | ||
PHILCO | PCM-1444-2044-2144 | Does not turn on when using the remote control | R908 |