PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TP1453 | No audio | R-408 or r-409 in my case it was the open r-408 | Replace and that's it | ELETRÔNICA CAVALCANTE |
PHILCO | PH24D21D VERSãO B | Does not turn on, only standby LED lights up | Voltages are all ok, trying to update via pen drive doesn't work, just rewriting the eprom solves it | Https://www.4shared.com/s/fuuuncgtmee | sergiomga |
PHILCO | TPF29S4F-TP33C21- TP29C21- TP2920 | R 1793 of 100 homs roasting | Lack of ground on the ew board | Reopen connector cm 701 | jasvan souza |
PHILCO | PH28S63 | Does not turn on blacklight | Vomiting | Tsound is no point in measuring | eletronica central |
PHILCO | PCM2044 | LED flashing, generates high and cuts intermittent | C720 47uf x 25 | Replace c720 47μF x 25v | EDIVAN ELETRÔNICA |
PHILCO | PH32S61DG | Red LED lights up but then goes out | Update software | Edson SP | |
PHILCO | TP1410 TP2010 | Does not turn on, relay keeps knocking | R927(120kω) open | Replace r927 | Edson SP |
PHILCO | PH21B | Does not turn on, LED flashes quickly with a clicking sound | Capacitor c438 burst and horizontal output d1555 with leak | Replace them | bse eletros |
PHILCO | PH21MSS | Turns on, a list appears as if you were touching the screen and turns off | Change electrolytic cap on the secondary optocoupler, transistor 2n5551 and rewrite the memory | DJ PITUKA | |
PHILCO | PH21M-SS | Missing red color | Bad tube | Kinescope | Joebson Sat |
PHILCO | PH29 US A2 | Horizontal light strip at the top of the screen. more visible with blue screen. | Change capacitor c 404 of the vertical circuit | sergio | |
PHILCO | PH24M | Does not turn on, LED is on | Remove the flat that goes to the screen, if it turns on and the screen is defective | In my case it was the screen that was bad. | Josemar afonso |
PHILCO | PH21M2 TUBO | Does not turn on standby off all battery voltages zero primary capacity charged | Open r521 of 121k only rings for the same value | CÉSAR | |
PHILCO | PH21M SS | Turn on LED blinks and does not turn on. | In my case it was the primary power supply electrolytic 220nf 400 volts. | Capacitor gets very hot. | luiztvsom |
PHILCO | PH21MSS | The stand by turns on but when pressing the keys the LED flashes and lights up again with a noise on the fly back, +b with 20v when you press the key it rises to 115v and drops to 20v again | Ic301=la70141 | I replaced and ran to another one | Antonio Carlos (Eletrônica Renascer)Boa Vista do Gurupi-MA |
PHILCO | PHT660N STA540AI | Tsound is no sound | -12v power supply very low and has no sound. | Changing the r59-100k resistor and changing the 47μF - ce206 capacitor on the logic board. measure l102-smd, check q1 and dz1 12v. | LUCIANO ALQUEJA |
PHILCO | TP1410 | Does not turn on with standbay turned off without +b power supplys | Capacitor 150por400v and the tea1507p shorted due to an energy discharge | I put the new components in and the TV was good again | Lambuquenta eletrônica |
PHILCO | TCS-2956 | TV turns on, normal sound. image missing to fill the horizontal sides. with cushioned effect. | Resistor r-722-10r 2w e replace do capacitor c-707 bipolar 6,8mf-50v | Giovanni George de Paula | |
PHILCO | PH21M SS | It only stays in standby when you activate the key, the LED goes out and then starts flashing, +b power supply with just 20v | Cause: semi-open d813 diode | Klein | |
PHILCO | PH800 | I'm sound | Q205 s8550 collector base short, check q212 s8050 | Q205 replace for db140, q212 for using bc548. | carlossbs |