PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TP2010 | The power is off and the speaker is making clicking noises. | Lack of grounding on the gnd pin of the speaker and ci tda7267a | I did a grounding jam and it resolved, it was fine. | Eronaldo |
PHILCO | PH1100M | Only has sound from the subwoofer | D5 in short | Replace the d5 on the main board next. at the exit. I put the ss210 smd diode (2a-100v) in its place | Lucafer |
PHILCO | PH24A | The LED turns on after a few seconds and goes out. Note: the more you try to turn it on, the less time the LED stays on | Replace the two 16v and 1000uf power supply capacitors | Valtenei | |
PHILCO | TPF2121 | It doesn't turn on when you press the button, the LED blinks and returns to the standby | I verified that the power supply voltage fluctuates between 90 and 115 volts and the horizontal transistor is slightly heated. | Flyback burned out, just replaced and resolved | jnunes |
PHILCO | TV PH21MG SS | Does not turn on, standby LED is on | When you press power to turn on the LED just blinks and doesn't turn on | Replace diode position on board d813 | Eletronica_Almiro |
PHILCO | PH21M SS | Blinking LED does not turn on | Transistor q.801_8050 and diode d820 | Washington de itauna mg. | |
PHILCO | PH21M SS | Blinking LED does not turn on | Diodo d820 | Vicente aparecido | |
PHILCO | PH24M LED A 40-00MS09-MAC2XG | Only black image turns on, control or panel keyboard does not work | Cold solder on the processor | In my case I performed a reflow with a heat gun, but it is advisable to do a reballing. but if you choose reflow, just blow the hot air at a temperature of around 235ºc for 1 (one) minute and a half. | Capiroto |
PHILCO | PH21 US A1 | Turns on and off quickly | C450 =681 | Replace c450 near the buster cap | DJ PITUKA |
PHILCO | PCM 1446 | Vertical closed | R606 open | rogerioeletronica | |
PHILCO | PCM2046 | Normal sound completely dark screen even when opening the screen completely, without the scratch on the screen. | Burnt vertical outlet | bene eletronica alfenas | |
PHILCO | TP-2052N | Water has dropped, it doesn't work, the LED doesn't light up but tsound are secondary voltages | Trafo do driver horizontal | Eletronica Lelo | |
PHILCO | PH29USA2 | Vertical closed | Electrolytic capacitor 1000uf/25v c 563 I changed it and April | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | PH29USA2 | Vertical closed | Electrolytic capacitor 1000uf/25v c 563 I changed in April | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | PH91 | Tsound is no audio. | EC404 electrolytic cap (100uf/16v) leaking. Responsible for the ripple cut, leaving the IC401 audio output inoperative. It was replaced and the problem was resolved. | José Luiz Enguer Pereira | |
PHILCO | PH21M SS | Red screen with lines of retractions. | Transistors fb 422 and 423- tube plate. Note: change all | Replace the same | BARRETO CRUZ |
PHILCO | PCS-2700 | Turns on normally for approximately one minute, then saturates red. | At first I thought it was the processor since the last pin measured 3 volts and was supposed to measure 0 volts and this corresponds to the color red. but I bet on memory. | I replaced the memory with another one and the problem was solved. | ORCLEY |
PHILCO | PH200 | It turns on, but the display is off. It only has the volume button on. | U9. change and run for the hug | ||
PHILCO | PCM2046 | Screen with shaking and crooked image with a shadow outlining people | Capacitor 915 1000 x 35 and saw 201 filter and small electrolytic capacitors of 2.2u 2 10u around the handyman | These two components must be replaced and the small 2.2u and 10u caps are just three | lucas |
PHILCO | PC1446 CPH-05 | High voltage spark between the cold part and the power supply by the foot of the capacitor c924. | Replace do flyback b32 3454 | Eletrônica R-TEC |