PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TP-2052N | Has sound and no image | Defective imaging tube | Replace the tube. | eletroclaudio |
PHILCO | PCM 2044 | Brightness does not work | R 124 open, close to colors | mauricio | |
PHILCO | PH21B | Fully closed vertical | Yoke ou bobina vertical | On the black wire on the coil terminal solder tsound is oxidation, check diodes 566 and 564 work. with 12v only one is positive voltage the other is negative | antonio dos santos lima |
PHILCO | TV PH29 US A2 | Image of half of the screen from the middle up with retrace line | Resolder the drive pin called shop which outputs 14v passing through the vd564 diode | Resolder the transformer pins | Eletrônica Ceará |
PHILCO | PH21MSS | Red screen with lines of retractions as if rgb resistor | Defective image tube on the red kr red pin burning the 2k7 resistor position r529 | Replace the tube. | EletroClaudio Aguas Belas |
PHILCO | PH21MSS | Red screen with lines of retractions as if it were an rgb resistor | Defective imaging tube on the red kr red pin! | Replace the tube. | EletroClaudio Aguas Belas |
PHILCO | TP2054 00000 | Replace r919 everything came back normal | R919 changed, it is not secondary to the power supply | Replace r919 everything came back normal | marcos melo |
PHILCO | PH21SS | Does not turn on, LED is off and tsound is no +b | R520, r521 e n501 | Replace them | Danieleletronica |
PHILCO | PCS2976S | TV with flay back leaking high voltage | Burst pacifier couldn't find the flay back of model jf0501-2156 | So I looked for a replacement model jf0501-19277 which worked, it also works for the TV models Philco PCs 2976, 2976s, 2978, 2996s, TPF2922, TPF2121, sound's a tip for everyone | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILCO | PH21B | TV with sound without image, without screen voltage and when releasing the CRT board the voltage reached 400v | Loss of eprom data | Eprom rewriting | eletronica c.r. |
PHILCO | PH21MSS | Low power supply with only 20 volts | C 850, 47mf/25v | silvano vds | |
PHILCO | PC-1443/2043 | Turns off after 5 minutes stuck | Change the eeprom memory (80011) | Ademar / Videira s.c | |
PHILCO | 1443/2043 CPH-05 | Side lane | Perfect image but running a side lane from right to left | Replace electrolytic capacitor c-722 of 470μF x 25 volts that is attached to the 7809 regulator | Ademar / Videira s.c |
PHILCO | PCM-2044/46 | No sound, no image, the LED keeps flashing | Open track between the transformer driver pin (t-702) and the q-702 collector | Ademar / Videira s.c | |
PHILCO | PH14/21/29 | Turns on, turns off or does not turn on | Replace o transistor v502 (2sc2383) | Ademar / Videira sc | |
PHILCO | PH21B | Turning off in seconds | R552 changed | MARCONDES LIMA,Jaicós-PI- Brasil | |
PHILCO | PCS 2952 | No video "has sound and characters but no channel image" | Check q 301 and or its aggregates | Master Eletronica | |
PHILCO | PT-2054 | When I plugged it into the socket the LED would light up, I would press the power button and it would take about 5 seconds and the LED would start blinking, setting up protection. | It was the fly-back that was shorted. | And just replace it and go to another TV.... | DIEGO LIMA NOVA TIMBOTEUA |
PHILCO | 29-USP | Closing on one side and with saw teeth | Replace c-402/406 (330pf 2kv) | Ademar / Videira sc | |
PHILCO | PH-21/SS | Vertical only half | Missing voltage -b on the vertical output, change without testing the vd-564 | Ademar / Videira sc |