PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCM-2046 | Turns on normally, after a few minutes it turns off and turns back on quickly. | Str 50103 | Tsound are several other components that cause this defect, in my case it was the str 5003 | ELTON CASTRO - EMBÚ- SP |
PHILCO | PH29USA2 | Vertical without deflection from the middle upwards | Vd401 open | Replace for 1n4007 | SADER |
PHILCO | PC-20R42 CPH-04 | Does not tune to low channels. | Ic-102 = la7910. | FERNANDO S | |
PHILCO | PCM 2044 | Inoperative, it seemed like a computer defect, it wouldn't start | R908 amended | Replace of the same | eletronicadoalemãThis email address is being protected from spambots. You need JavaScript enabled to view it. |
PHILCO | PCM 2044 | Inoperative, it seemed like a computer defect, it wouldn't start | R908 q | eletronicadoalemãThis email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | UOC TDA11145 | No audio over rf. all models that use tda11145 | Capacitor 10x16(c317) devalued | inadim | |
PHILCO | PH21SS | Screen from the middle to the top with venetian blinds and deformation on the sides | VD401 and VD565 diodes replace without testing | ercilio eletronica televideo guarapuava pr, | |
PHILCO | PH 29 | Doesn't start | Replace open 120k resistor | N°520 on the power supply board | pfa |
PHILCO | PH29B | Works normally and when it turns off it doesn't start again (it works and stops) | Q804 q805 change them | This email address is being protected from spambots. You need JavaScript enabled to view it. (Bruno) | |
PHILCO | PCM2046 | White screen with no image and function frozen. | 180v line capacitor | noel batista | |
PHILCO | TP2052N | TV with 10cm + - closed at the bottom of the screen with retraction lines | Eprom memory, just re-record it and go to the hug | MARCIO ALVES | |
PHILCO | PH 14E | Power supply inoperative. LED does not light up | R= 881a near the open flayback | I replaced it and plz | ELETRONICA MEDEIROS |
PHILCO | TP 2052N | TV does not turn on, LED is on, power supply is normal, has five volts on the micro and a 20 volt supply; however, it does not have the 180 volts from the screen or the 33 volts from the varicap. | Causes faulty flay-back. | It was replaced and resolved. | Armando de Ólímpia , Eletronica EvoluSom. |
PHILCO | TP-2054 | Does not open vertically, turns off | Ic905, regulator 7809 | ||
PHILCO-HITACHI | PC20R38 CPH-04 | Inoprant ttv. +b 91v, 5v from the micro processor and 8v from the perfect on chip. | Tranformador draive horizontal. | T702 transformer. | Ademir tc |
PHILCO | PCM 2046 | I'm sound | C414 | C414 1000x25v | ELETRONICA MAURIJUNIOR |
TV PHILCO | TV PH 21SS | TV turning dark greenish or bluish | V-923 on r.g.b bf423 board with daughter on emitter | Replace and analyze all | ELETRONICA MEDEIROS |
TV PHILCO | PH21SS | Dead power supply does not turn on standby | R 522 100k | Replace 100k 1w | Luciano |
PHILCO | 2976 | Vertical not fully closed and smoking r709 (18r) | R910 and 912 (both are 0.47r) | HP ELETRONICA | |
PHILCO | PH21US A1 | It keeps turning on and off without an image, the screen increases and the vertical line is closed. | Transistor v502 (c2383) | Amram |