PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14192
Results: 14192
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 42PFL3008 | It just stays on standby and blinks in the backlight | Eeprom, remove eeprom, turn on the TV without the memory, turn it off, discharge the power supply capacitors, highlight the eeprom and that's it... solved | Luiz bhtechcenter | |
| PHILIPS | 40PFL5606 | Does not turn on, does not come out of standby | Memory stuck | Short out pins 5 and 6 of the 7702 memory to gnd on the main board and connect the TV to the socket, wait a few seconds, the TV will turn on, undo the short and the TV has its memory unlocked | Mitzko eletrônica |
| PHILIPS | 32PFL4707G/78 | doesn't start | u701 regulator. 3.3 volts | Replace 3.3 volt regulator U701 on the main board | Flavio |
| PHILIPS | FX30/78 | Dead | D3 shorted | replace diode 1n5822 no above | Rodolfo |
| PHILIPS | 32PHG5813 | Does not connect CLIETE 8817 | short diode ZD 705 ALSO REPLACE 712 IT IS THE REASON FOR THE DIODE TO BURN | REPLACEMENT . DZ705 ZENER DIODE 4V replace U712 | marcos melo |
| PHILIPS | 42PFL3403 | No sound from all outputs, including headphones. Tsound's a very soft \\\"Tic-Tic\\\" on the speakers | 2A04 and 2A08 (220μ/25v) hollow. Remove, clean and you can add PTH even respecting the height. | Mau3000 | |
| PHILIPS | 32PFL5604 | It works for 5 minutes and it beeps loudly and turns off | C474 near the u8, C527, C525 near the microcontroller, under the metal plate | HAHNRAHN | |
| PHILIPS | 50PUG6654 0000 | normal sound but no plot | broken display | I isolated the last 8 lanes on the left. Dormiuuu... good luck! | Jhone Eletronica |
| PHILIPS | FWC507 | Display off | Resistor 4.7 position 3211 transformer board. | JMC Eletrônica e comércio | |
| PHILIPS | 32MF605W | No sound, picture ok. | No Vcc Voltage on the audio processor. Check voltage regulator 7006 | Aaron Fresno | |
| PHILIPS | 50PFP5332 | Dead, LED flashes 6 times | Check C601 e C609 | Aaron Fresno | |
| PHILIPS | 32PFL3018/78 | TV doesn't turn on | TV TURNES ON BUT STAYS ON STANDBY FLASH MEMORY WITH COLD SOLDERING OR REPLACING U04 MEMORY | Fixing the welding defect solved the problem. | DINIZ16 |
| PHILIPS | 32PFL3404 | relay, 24v and 3v3 power supply ok and no action, no stand by | oxidation, general cleaning | mainly from below the processor chassis | Marcelo Schmaida |
| PHILIPS | 42PFL5422 715T2432-3 715T2432-3 | Does not turn on or turn off intermittently. | Power supply failure | Check replace C951, C952, C953 | Edson SP |
| PHILIPS | 32PFL3518G L12M3.1L LA cod.441 | INVERTED IMAGE | MAIN PCB ADAPTATION GAVE IMG INVERTED. IN THIS ADAPTATION I USED THE PCB FROM A PHILIPS 39PFL4508G/78 (COD.445) | ENTER SERVICE MODE BY TYPING: TYPE ON THE REMOTE CONTROL: 062598+MENU+441 (code on the label on the back cover) | EVANDO VIANA |
| PHILIPS | 42PFL4007G/78 715g5172-m01-001-004b | The TV turns on stuck on the logo, sometimes the channel starts, the command freezes and restarts. | U415 (G1084) replaced on the logic board | U415 replace | Beto , eletrônica box 4 |
| PHILIPS | 32PFL3017 | HDMI inputs and digital channel tuning failure. | U502 open and U501 shorted | replace them | BARBADINHA |
| PHILIPS | 43PFG6825 | TV turns on, has sound, turns on the LEDs, but tsound is no image | Smd capacitor on t.con c28 board shorted | RJ Eletrônica | |
| PHILIPS | 58PUG6654/78 | Blacklight on but screen without plot | Capacitor vcon c59 curto | Replaced sleep.... good luck! | Jhone Eletronica |
| PHILIPS | 32PFL3406 32PFL3606 | Does not turn on or standby | F100 - q101 and q102 only showed 3.3v | C600 1μF x 450v polyester capacitor | Fernando S |