PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14192
Results: 14192
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | FWD789/55 | Does not turn on, shows signal on display | Q906 short caused by glue | Glue cleaning and component testing | Junior de Conto |
| PHILIPS | 14PT3131/78R | turns on but doesn't go into AV and with vertical closed at the bottom about 5 cm | Memory | replace or replace the memory (in my case I replaced it and it worked) | DTEC-ELETRONICA-Massapê-ce |
| PHILIPS | 14PT3131/78R | Turns on the picture for 5 seconds and turns off (either in Av or Channel) | Memory | Re-record or replace (in my case I replaced it and it resolved) | DTEC-ELETRONICA-Massapê-ce |
| PHILIPS | 49PFG5001/78 | IT TURNED ON NORMALLY, BUT AFTER ON AVERAGE 33 SECONDS, after showing an picture, IT TURNED OFF AND STAYED IN STANDBY WITH THE RED LED ON, WITHOUT BLINKING, IT SIMPLY TURNED OFF AND DOESN'T TURN ON AGAIN BY ITSELF. SO EVERYTHING INDICATES THAT IT IS REALLY AN UPDATE. | SOLUTION WOULD BE TO replace THE NAND FLASH MEMORY ALREADY RECORDED OR UPDATE WITH THE FILE THAT IS IN 4SHARED FOR THOSE WHO HAVE A NAND RECORDER. BUT OUT OF CURIOSITY I ACCESSED THE PHILIPS WEBSITE External Link... < /a> and downloaded the software update that is tsound. | AND BY COINCIDENT I SAW THAT IT WAS AN UPDATE THAT SHOULD BE MADE IDENTICALLY TO THE AOC LINE, THAT IS, WITH THE FILE DOWNLOADED AND ON THE PEN DRIVE SHOWN ON THE TV, THE TV ON STANDBY, PRESS VOLUME +, HOLD IT DOWN, PRESS POWER AND KEEP PRESSED UNTIL THE STANDBY FLASHES OR OFF AND RELEASE VOLUME AND POWER AND THE TV DOES THE REST. DON'T BE SCARED, IT DOESN'T SHOW AN UPDATE BAR, ON THE CONTRARY IT JUST GIVES A FEW RANDOM BLINKS ON THE LED, AFTER IT GOES RIGHT THE TV TURNES ON BY ITSELF, REMOVE THE PEN DRIVE AND IT COMES IN BURN IN (GREEN RED BLUE WHITE), JUST ACCESS MENU AND CONFIGURE FACTORY RESET, READY, RUN FOR A HUG... | MIGUELTV |
| PHILIPS | 48PFG5509 | No picture but backlight on | Replacement of C715 with short on Tcon board | BHTECHCENTER | |
| PHILIPS | TBM-C830 | cd only plays the first 5 tracks | cd rotating motor tray | After replace the optical unit, it was necessary to lower the CD rotation motor tray a few millimeters, if you lower it too much the CD could scrape, I placed an old credit card between the motor and the tray and pressed it down. | jorgetec |
| PHILIPS | 65PUG7406/78 | Does not turn on standby off | C322 c328 shorted on main PCB | Replace c322 or c328 | |
| PHILIPS | 42PFL7007 | does not turn on at 3.3v from the power supply | q301 kst2907a defective | resistronic resende | |
| PHILIPS | 32PFL3606 | Does not start, dead, with 3V3 of the STB | 12V power supply, 24V did not work, L6599 replaced, PFC was also low, I removed and cleaned the glue from the reference resistors and it stuck at 390V. | Davi.sls | |
| PHILIPS | 58PUG6654/78 | backlight access without picture | shorted capacitors on vcon | c95 left side of the vcon and c56 right side | DoorneL |
| PHILIPS | 58PUG6654/78 | backlight access without picture | shorted capacitor on vcon | c56 short right side of vcon | DoorneL |
| PHILIPS | 21PT8467/78 | Strip of about 3 fingers on the top (vertical closing) | replace the 2 capacitors c2465 and 2446 and run to the hug | Mack Ramos. Eletronica sao carlos | |
| PHILIPS | 42PFL3007/78 | No signal or LED lights up | Tsound is no 5v at the output Replace the capacitor c9353 (330/16) | Replacement with 470/16v electrolytic capacitor resolved | |
| PHILIPS | NTRX300X/78 | No audio | Broken 30v power supply | Check and replace 2200x50v C26 capacitors... | Medeiros Eletrõnica Barbacena MG |
| PHILIPS | 32PFL5604 | RED STAND-BY LED ON AND DOES NOT TURN ON | C474 (4,7µF/16V) | I put 10µF/16V electrolyte and works fine | RYK |
| PHILIPS | 231TL4LB | Picture go on and go off | Coil L8708 | EletroClaudiope | |
| PHILIPS | 14GL1310 gr1al | low and rumbling sound | ts620 bc338 open | replace this transistor, check the pair ts625 bc328 in this case it was good | orlando lott |
| PHILIPS | 39PFL4508G/78 L12M3.1L LA | picture INVERTED AFTER REPLACING THE MAIN BOARD | IN SERVICE MODE TYPE ON THE REMOTE CONTROL: 062598+MENU+OPTION CODE WHICH IS ON THE TV LABEL, IN MY CASE THE TWO CODES WERE 445 BUT THE picture WAS INVERTED I TRIED 446 THE picture WAS IN THE RIGHT POSITION BUT NEGATIVE THEN I TRIED 444 AND THEN YES, EVERYTHING WAS NORMAL (WHENEVER YOU TYPE THE CODE, THE TV SHUTS OFF THEN IF IT CANNOT PROVIDE VIDEO AND JUST REPEAT THE PROCEDURE WITH THE TAG CODE | Roberto freire _ @pointinformatica6431 | |
| PHILIPS | 32PFL3605D/78 slc 10.1llA | doesn't start | c502 of 100x1kv burst, fet Q501 6nc80c and R514 of 10 homs smd. also open fuse | J.Dantex | |
| PHILIPS | 42PFL3604 | Backlight flashing | Contact lamps display | Repair connections | Angelo MG |