SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CL29C560GQ 9XZD | Doesn't start | The problem is ic801 s =strw6754. | Replace the ic801s=strw6754==if you have difficulty finding the original, use the strw6753, it works | juralima |
SAMSUNG | CW-28D83N KS3A | Nothing happens, the LED doesn't even light up (dead) | Capacitor does not discharge | Replace c808 capacitor in the power supply | ALACYTE |
SAMSUNG | MAS-A55TD | CD tray with little strength to lift the optical drive | Zener diode that acts in the ci drive that controls the motor that cams to the tray | I put a diode with the highest voltage 9v if it gets too fast put a lower voltage 88178817 | marcos melo cascavel ceara |
SAMSUNG | CX-6844N | When we turn it on, the red LED lights up and turns orange and does not start. | C829 - 100uf / c835 - 470uf / c405 - 2.2uf / ce01 - 220uf(jundo osclilador horizontal) | Replace capacitors and resolder the entire board | This email address is being protected from spambots. You need JavaScript enabled to view it. |
SAMSUNG | CN 5048V | Saw tooth reduced frame | Ic 201 | Tda 8374a | Felex |
SAMSUNG | CN3348V | Does not turn on relay knocking | 0.22 r resistor r409 open near the fly. | Eletroclaudio Aguas Belas PE | |
SAMSUNG | CN-3355Z | TV stopped, power supply only with the primary, without the 125v that feeds the horizontal output. | Horizontal output transistor d1711 shorted, causes bad contact in the t401 drive and in the horizontal osc;tr q401. | The TRD1711 was replaced and the oscillator circuit was resoldered and it looks great. | Armando da eletrônica só tv |
SAMSUNG | LN26A330 | Without image and with sound | Inverter board fuse f4 | aspen | |
SAMSUNG | CL-21Z50MQ | TV generating with screen off. screen with 0 volts | Kinescope screen pin shorted | In my case I removed the short with the series lamp connecting the pin to the kinescope grid | ANTONIO NOBREGA(PATOS PB) |
SAMSUNG | CL14B501KJ | TV inoperative, burning fuse | It was the 220uf 400v power supply capacitor in short | Eletroclaudio Aguas Belas PE | |
SAMSUNG | CN-3383V | Turns on, but tsound is no image. By increasing the screen, the horizontal appears shrunken and overlapped. | Deficiency in pre-horizontal power supply caused by diode 405 | Ronie Grein | |
SAMSUNG | CB-20S20BT | Turns on, perfect image, after a few seconds the image becomes grainy | Capacitors and cold solders, on the chassis and inside the tuner | Replace critical capacitors, and resolder complete boards | This email address is being protected from spambots. You need JavaScript enabled to view it..p |
SAMSUNG | 794S | Flyback beeping and power supply disarming | 0.6Ω r506 changed | Replace the resistance | MARCOS ROBERTO |
SAMSUNG | CN3383V | Does not tune to loud channels, only makes scratches on the screen on loud channels. | R of 3r3 with changed value inside the selector on pin bp(5v) feeds internal ci of the selector. | Bruske | |
SAMSUNG | LN32A330 | Saturated image | Replace ic 6002 - lm358d | GEORGE | |
SAMSUNG | CB-20F12T KS1A | Image goes back and forth after adjustment in tl | Change capacitor in c802 power supply | alacyte | |
SAMSUNG | CL21Z43MQ | It only works if it says it fits, the tube plate looked like it was the tube but it wasn't | It was broken tracks at the foot of the flyback | Splice or weld splinters | Eletroclaudio Aguas Belas PE |
SAMSUNG | CL29Z58MQ | Dead | Simple flyback | Taking the output, I verified that all voltages appeared, in the +b of the flayback the voltage is 130 v. It was 165. This is normal because the flayback was bad, when I replaced it the voltage went to 130v. it cost!!! | XANDEDANTAS |
SAMSUNG | CL29A551GQ | Turns on std by blinks and doesn't turn on | L lr404s auterated diode with leakage transistor qw402 shorted | I found the leaking diode, diode 404, I replaced it and the TV started to work but with a faulty pad, I replaced the qw402 transistor, I could put an IRF 630, but the ATV continued to have the defect, the aumofada, so after examining the components, I found the lr404s a little toast, so I replaced it with a Another one is 3.0mh, I put a 1.0mh one in and the TV started working again, defect brabinho oxente if god and for us who will be against us. let's help everyone. | fernando timbauba PE |
SAMSUNG | CN5083 5083VB | Excess brightness with horizontal lines. | R409 changed vertical feed. | João SF. |