SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CL21M6MG | White lines across the screen | Tube socket | Replace the same | This email address is being protected from spambots. You need JavaScript enabled to view it. |
SAMSUNG | CN7202 | TV with very weak standby and ñ part | Capacitor 814, photocoupler, dz806 power supply | Carlos2013 | |
SAMSUNG | PS-42D4S D65C | Turn on the TV. There is audio but no image, after a few minutes the image appears. | I replaced the power supply capacitors, but the fault still remained. When ci1 was heated at the power supply it turned on immediately, it's strange but soon after replacing ci1 (ml4824ip1) the fault was resolved. | This email address is being protected from spambots. You need JavaScript enabled to view it..p | |
SAMSUNG | 29 | Activating the protection, with vertical closed. | CV918 capacitor shorted, 1000/ 10v | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
SAMSUNG | CL21K40 | Vertical 2 fingers above | The flyback was changed and the ommy flyback batch was defective [the minus 16 only gave 7 or exchange for another good one or wind 4 turns on the 16 turns | NENO DO ERYSOM DO JURUNAS | |
SAMSUNG | CL 21K 40 | Vertical 2 fingers above | The flyback was changed and the ommy flyback batch was defective [the minus 16 only gave 7 or exchange for another good one or wind 4 turns on the 16 turns | ||
SAMSUNG | T220M | Turns on and then turns off | Cap. 680x25v na pci power supply | eletronica bianca ipira-ba | |
SAMSUNG | LN32B530P2M N70 | With sound without image | Invert does not start | Place 1 4k7 resistor from pin 16 of the ci 2006 to pin 23 of the cm 802 | jorge-ivoti |
SAMSUNG | CL29K40 K16A | Closed vertical, also lacking horizontal width (about a finger's width missing on the sides) | Deflector coil (yoke) with one of the vertical coils open. | nacionaleletro | |
SAMSUNG | CL-29K40 | No video sound | Testing cun analyzer and rest. d tube after several tsts dtctei red cannon with low emission. | I reactivated it and that's it. | This email address is being protected from spambots. You need JavaScript enabled to view it. |
SAMSUNG | CL21Z43MQ KSCA MANASLU2 | Cr406s sold out, it was replaced and the TV started working normally again, I hope I helped those who have this defect, note. The 100uf/160v capacitors are also swollen, both were also replaced but the defect was the capacitor mentioned at the beginning. | israel | ||
SAMSUNG | CL21M21MQ CL21M21MQ | Turns on normally with audio but dark screen. If you enlarge the screen, scratches and the screen flashing appear | R813 for 1r-1w | R813 for 1r-1w | neupsx4download |
SAMSUNG | CL-21Z43MQ | Doesn't start | Micron defect | Replace the | fernando ferreira |
SAMSUNG | CL20K40MQ | Reduced frame vertically and horizontally / without weft | Microprocessor | Replace the same | eletronicaapolo |
SAMSUNG | CN - 5083V | Reddish image. | R-917 and 923 amended. (crt board). | FERNANDO S | |
SAMSUNG | 32 | Does not turn on the screen only has sound | R 908 | Remover o resistor | Marcos |
SAMSUNG | DVD-R150 | No characters on TV screen, tray locked | No characters or images appeared on the TV screen either through the video or RF outputs and the tray was locked, with the word open appearing on the display. three 1000μfx10v capacitors (ppcf1/ppcf2 and ppcd1) were replaced. on the capacimeter they showed an average of 1,150μf but they were the cause of the problem. replaced with three 1200μfx16v removed from a motherboard, it worked perfectly again. | littlecarlos | |
SAMSUNG | CL21M6MQ | It wouldn't turn on: 1 n 805 diode and 1 n 812 dzener were replaced | Now turns on the power supply and the LEDs but the horizontal one stays on and off with the smaller frame and retraction line | JANUARIO VITOR | |
SAMSUNG | CL-29M21MQ | It doesn't work, only the stand by LED is on, press the power key, nothing happens, 6 VDC power supply measures 4.5 V | After changing all the voltage regulators, the microwave was also replaced (which was overheating) and the TV started working again. | EDGAR THIZ | |
SAMSUNG | CN-3329V | Noisy power supply on stand by | C852 changed. | After replacing it it was normal | Fuão |