SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CL-21K40MQ | Alloy has OSD and blue screen, but tsound is no image. | R423 82.5k precision resistor open. | Replace of it (tec edfesom, varjota-ce) | Edfersom |
SAMSUNG | LT22A300 | The standby LED flashes, it doesn't turn on | Dm881 at power supply shorted (3a super fast diode) | Baguatech | |
SAMSUNG | T27A550 | Completely inoperative, tsound was no 3.3v voltage in the memory. | Test ic 1204 3.3v regulator, next to the power supply connector, it looks like a transistor. If tsound is no voltage or it is low on the left side pin, you must replace it. | Eletrônica JJ | |
SAMSUNG | T24D310LH | Stand-by flashing 6 times | Senk13 processor overheating a lot, consider replacing the processor or replacing the board | ELETRONICA TRICK NIGTH | |
SAMSUNG | UN40H4203 | No image, backlight ok, sound ok | Com - shorted capacitor cd16 - cd34 - cd32 | Replace shorted capacitors | Paulo Braz - Braz Reparos |
SAMSUNG | CL21C650ML | Blurred image as if it were a tube socket defect | After a lot of suffering, I decided to change the vertical output and the TV worked, blz la78045 | Replace and run for a hug!! | orlando lott |
SAMSUNG | UN40D5000PG | Duplicate image | Place a 0.60 cm tape insulating the flat cable from track 12a18 from left to right on the t-com connection | Medeiros Eletrônica/Barbacena MG | |
SAMSUNG | UN48H4203 | Dark screen LEDs on Fuse burned out on display board Capacitor with SMD leak | Just take it off | fernando | |
SAMSUNG | LN37D550 | Posca led but won't turn on | Shorted capacitor | Smd capacitor c622 screen board | Tec Center |
SAMSUNG | MX-JS5000 | Tsound is no sound | Capacitor cs922 e transistor qs921 | Missing - 5v jp931 | BETO ELETRÔNICA ACRELANDIA ACRE |
SAMSUNG | UN48H4203 | Duplicated/shaky image | 1k RG6, TCOM board. change to 5k | Djalma Moreira | |
SAMSUNG | UN46F5200AG | Stand by LED lights up when you turn on the TV, the LED goes off and nothing else happens, it becomes inoperative | By disconnecting the main board from the power supply, the LED bars will start blinking and would have to light up at maximum brightness. | Rs 802 of 10r smd replaced to 155r in the power supply close to the cp 814s larger electrolytic of the power supply | REAL ELETRON CARVALHOS MG |
SAMSUNG | UN32F5200AG | TV turns on, has sound and back light comes on, but no image. | Defective t-board. | Replace the three smd capacitors cd23 cd22 cd21, altered, leaking, short (10μF) | RNSPTEC |
SAMSUNG | UN32FH4205 | Does not turn on, completely inoperative | 3v3 is missing from the RST on the signal PCI, check IC804, SOT-23 encapsulation, pins 1 you must have 3v3 | If you don't have 3v3 at the IC output, replace it, it's possible to adapt one from the 1117 series. | davi.sls |
SAMSUNG | F6800 F6400 | Doesn't start | Ci pwm ics801 = 2a153d sk372 | RMSeletronica | |
SAMSUNG | LN26A330J1 | White screen | Cp36 and dp3 shorted on the vcon board | Replace cp36 and dp3 | Eletronica EASI |
SAMSUNG | 42LB5600 | Mute sound and intermittent image at increasingly shorter intervals. | Defect in the t-con or the lack of heatsink rubber that is between the t-con and the chassis. Note that the back light stays on normally. | GILSON | |
SAMSUNG | UN55F6500AG | TV doesn't turn on, LED keeps flashing | Leaky component triggering protection, (t board with) | Leakage smd ceramic capacitor, tcom board (giving 450Ω of resistance, it is below r33 and above the ic sm4152 the smd is without nomenclature. | RNSPTEC |
SAMSUNG | UN48J5200AG | After a few hours the image gets lines until the image disappears | Shorted t-con | The same was replaced | marcelo rosa |
SAMSUNG | CL29Z58MQ | TV with slight hiss. do not form and as if fly back defective. and horizontal heating (burned 1x) | Vertical. I took the TV off and it worked. I changed vertical. |