SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CL21C650ML | With a crooked line in the middle of the screen | Change vertical exit la 78045 and run to the hug | Eletrônica Power | |
SAMSUNG | LN26B350 | Queima ic 1001 9933b | Change cover. 2019,2026 | Thanks for the tip ok | cezar |
SAMSUNG | PL51F4000 | Doesn't start. flashing standby led | I replaced the 30m40 igbts on the y sus board. all shorted. | Rmseletronica | |
SAMSUNG | PL43F4000AG | Doesn't start. LED lights up and flashes and does not turn on | Cold solder on the power supply board. | Resoldered the power supply board and the TV started working normally again | Duliz180 |
SAMSUNG | PL50C450B1 | Greenish/negative image | Igbt na y-sus | Replace the faulty rjp30e2 on the y-sus. | Weslley (UNITEC) |
SAMSUNG | PL50C450B1 | Small image, black band on screen. | Resistors | On the main board near the power connector replace the resistor r491 to r490 or vice versa. | Weslley (UNITEC) |
SAMSUNG | CL21C650ML | Vertical closing at the bottom | D301 | D301 | Eletrônica Mauri Junior |
SAMSUNG | PL51D451 | Image does not appear flashes stand-by | Replace diode d5010,q5001,q5002,q5017,q5009 (rjp30h1) can replace with30f124 | speedtec | |
SAMSUNG | UN32FH4003G | TV turns on after a few minutes, turns off and turns on again, you notice that the LEDs keep oscillating | A 47uf/160v capacitor was found to be dry on the power supply board | After changing it, the TV started working normally again. | Adriano Miranda |
SAMSUNG | UN32EH4000 | Flashing, backlight lighting | Main board | Replacement | Roberto Costa |
SAMSUNG | UN32D4000 | Backlight flickering, unstable and dark | Q9102, faulty LED driver | Percí | |
SAMSUNG | PL43F4000 | The standby LED flashes, the va/vs/vsc voltages reach their peak and the power supply is tripped. | Short in the smd transistors at the power supply. It is a line of 4 transistors. The correct thing is to change them all. positions q4002, q4003, q4004 and q4005 | I may be wrong with the positions, but if you measure the transistors you will find a short | PL ELETRÔNICA |
SAMSUNG | LN40D550 | Image shakes, both from the middle up and the entire image shakes, this tip is worth it | Replace resistor r144 on the 47k screen board with one from 15k to 27k (use a 50k trimpot to determine the best value) | HP ELETRONICA | |
SAMSUNG | LN40D503 | Image shakes, both from the middle up and the entire image shakes, this tip is worth it | Replace resistor r144 on the 47k screen board with one from 15k to 27k (use a 50k trimpot to determine the best value) | HP ELETRONICA | |
SAMSUNG | LN32D400 | Duplicate screen tv without t.con | Resistor rd14 7k place 15 k on display board | Duplicate screen remove rd14 7k and replace with 15k | Luis Carlos rasa |
SAMSUNG | CL14C600KJ | TV, stopped when turned on, the LED does not light up and without +b | After the power supply stage I detected r821 - 100k open special 5-band resistor it could also be r821b that works in parallel | José Santana,,, Sergipe | |
SAMSUNG | T24B350 | Does not turn on completely inoperative | Change voltage regulator strw 6053 s and 47j / 1kva capacitor that is on the IC terminals | Denilsonti75 (epinfor) | |
SAMSUNG | 24B350 | Does not turn on completely inoperative | Change voltage regulator strw 6053 s and 47j / 1kva capacitor that is on the IC terminals | Denilsonti75 (epinfor) | |
SAMSUNG | UN40J5200 | Enlarged image. It looks like a zoom was made and it doesn't go back to normal. In a close up, people's noses appear upwards. It is not possible to access the screen footer. | Screen defect. | Screen replacement. | arock |
SAMSUNG | PL43F4000 | 5v from the power supply pulsing stand by off | Defect in the 2 blue capacitors cq804 and cq805 | 2 blue capacitors cq804 and cq805, both 2.2nf x 1000v, next to the diode matrix dq807 and dq808, replace them even if they are good. | SILNEI |