SEMP TV Repair: Common Faults and Solutions.
Search: SEMP
Results: 2828
Results: 2828
SEMP Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP | TV2123(O)FS U-19 U-19 | Does not turn on, LED blinks | C446 (250v 4,7uf) | Baguatech | |
| SEMP | TV2134 | Turns on and then turns off | C634 47/160 replace it and go for a hug | jandir cristo rei | |
| SEMP | 2982 | Does not memorize channel 3 | Replace a memoria (eeprom) smd 24c16 | Ademar Videira sc | |
| SEMP | U16 | Dark image | R 227 (27k) smd | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| SEMP | TV2134 | Turns on, generates high voltage and then turns off. | He replaced the 47x160v capacitor c634, which was out of capacity. it turned out great. | nachbar | |
| SEMP | TV-2922 JFS | When turning on the device, the LED lights up and then goes out. | Q-850, optical coupler, close to the power supply str. | Replace it, it's ok. | Cláudio Ribeiro, TECNOSAT ELETRôNICA E INFORMÁTICA, Jataí-Go, This email address is being protected from spambots. You need JavaScript enabled to view it. |
| SEMP | TV1454 | I'm sound | Resistor (r604) aberto 2r/2w | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| SEMP | TV2134KSY | Turning off and on | Saida vertical ic 301 = la78141 | The replace of the same | HIPERELETRONICA SERVICE (MARCELO MARAIAL-PE) |
| SEMP | TV2090 U14 | When turned on, tsound is a brief hiss and it only cuts out and only turns on again if the main capacitor of the power supply is discharged. | Try turning it on and off without arming the protection, sometimes notice if the fly bek feels on the foot | Fly bek | edezio eletronica |
| SEMP | 2934 (B) SL SK-91 | Vertical closed | Diode (d-306) aberto | Replace it for a sk4f1/10 | Ademar Videira sc |
| SEMP | TV2052 U19 | Low power supply +/- 60volts and pulsing | C-865 10k shorted | Replace | LUCIANO |
| SEMP | 2134 (B) | Closed horizontal | Q606 | To replace | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| SEMP | TV2084 | Defective fly-back, sparking | After changing the fly, the TV had a blue screen and no characters | D901 on the kinescope board (1n4148) and short. replace the same | Eletronica Staub |
| SEMP / TOSHIBA | TODOS | Everyone who uses the bu 808-dfi and it heats up too much, or shorts out | Definitive solution | Use the transistor (2sc 5902) in place of bu 808, retighten the capacitor (c-419) and place a 100 x 63 volt one, add a 1n 4148 diode in parallel with the c-419, connect the katode to the negative of the capacitor and the anode on the positive, remove the resistor r 426 or r 427 and place a 0.47 obms resistor, tsound is no need to place a heat sink | Ademar Videira sc |
| SEMP | 2091-KAV | Vertical closed | Check regulator q-421 (7805) with cold welding or open | Ademar Videira sc | |
| SEMP | TV2134 SL SK11 | Image with excessive brightness contrast does not adjust | Electrolytic capacitor 4;7x250 position c329 with broken pin | To replace | Vanin eletronica megatron |
| SEMP TOSHIBA | LC2640W HL57 | No sound or popping and varying volume | Cto 18v. | Replace of re 552 (6k2) for 4k7 or 3k9. pin 4 tpc8111. smd | joaomvj |
| SEMP | TV2158NFS U18 | The LED is blinking and the supply is low +b with 48v | Substituir c865 (10k) | joansa eletronica | |
| SEMP | TV2091KAV U15 | Turn on the LED, it oscillates and goes out quickly, it takes a while to turn it on again | Shorted vertical output | TDA02 = ao tda8177 | Ádrian Chapadão do Céu-Go |
| SEMP | LC2640W HL57 | Sound popping up, sometimes it gets low and then suddenly gets loud. | Reg. 9v qe53 regulator power supply board, the board after the power supply. | Replace ic | joaomvjr |